Search results
Results from the WOW.Com Content Network
The Federal-Aid Highway Act Amendments of 1974 established the bridge formula as law, along with the gross weight limit of 80,000 pounds (36,000 kg). Current applications of the formula allow for up to 7 axles and 86 feet or more length between axle sets, and a maximum load of 105,500 lbs. [2]
For measuring length, the U.S. customary system uses the inch, foot, yard, and mile, which are the only four customary length measurements in everyday use. From 1893, the foot was legally defined as exactly 1200 ⁄ 3937 m (approximately 0.304 8006 m). [13] Since July 1, 1959, the units of length have been defined on the basis of 1 yd = 0.9144 ...
All GMC Motorhomes are 96 inches (240 cm) wide and about 9 feet (2.7 m) tall including the usually-installed roof air conditioner. Interior head room is 76 inches (190 cm). Gross vehicle weight rating for the 23-foot (7.0 m) coach was 10,500 pounds (4,800 kg) and 12,500 pounds (5,700 kg) for the 26-foot (7.9 m) coach.
Quoting a dry weight can make a car's weight and power-to-weight figures appear far more favorable than those of rival cars using curb weight. [4] [5] The difference between dry weight and curb weight depends on many variables such as the capacity of the fuel tank. There is no standard for dry weight, so it's open to interpretations. [5]
The measurement of altitude in international aviation (the flight level unit) is one of the few areas where the foot is used outside the English-speaking world. The most common plural of foot is feet. However, the singular form may be used like a plural when it is preceded by a number, as in "he is six foot tall." [8]
With power typically being the product of force and speed, a motorcycle's power and torque ratings will be highly indicative of its performance. Reported numbers for power and torque may however vary from one source to another due to inconsistencies in how testing equipment is calibrated, the method of using that equipment, the conditions during the test, and particularly the location that ...
The term, yard derives from the Old English gerd, gyrd etc., which was used for branches, staves and measuring rods. [5] It is first attested in the late 7th century laws of Ine of Wessex, [6] where the "yard of land" mentioned [6] is the yardland, an old English unit of tax assessment equal to 1 ⁄ 4 hide.
Conversion of the Mach unit of speed depends on the altitude at which the speed is measured. That altitude should be specified either in feet (for example, |altitude_ft=10,000) or in metres (for example, |altitude_m=3,749). The altitude cannot be determined accurately and only a whole number is accepted. Examples: