enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Registered jack - Wikipedia

    en.wikipedia.org/wiki/Registered_jack

    The RJ standards designations only pertain to the wiring of the (female) jacks, hence the name Registered Jack. It is commonplace, but not strictly correct, to refer to the unwired connectors or the (male) plugs by these names. The nomenclature for modular connectors is based on the number of contact positions and the number of contacts present.

  3. Modular connector - Wikipedia

    en.wikipedia.org/wiki/Modular_connector

    The first types of small modular telephone connectors were created by AT&T in the mid-1960s for the plug-in handset and line cords of the Trimline telephone. [1] Driven by demand for multiple sets in residences with various lengths of cords, the Bell System introduced customer-connectable part kits and telephones, sold through PhoneCenter stores in the early 1970s. [2]

  4. ANSI/TIA-568 - Wikipedia

    en.wikipedia.org/wiki/ANSI/TIA-568

    Perhaps the most comprehensive known and most discussed feature of ANSI/TIA-568 is the definition of the pin-to-pair assignments, or pinout, between the pins in a connector (a plug or a socket) and the wires in a cable. Pinouts are critical because cables do not function if the pinouts at their two ends aren't correctly matched.

  5. Telephone jack and plug - Wikipedia

    en.wikipedia.org/wiki/Telephone_jack_and_plug

    Before c. 1930, concentric connectors with three contacts were usually sufficient, but the upgrade of telephone sets to anti-sidetone circuitry in the 1930s required at least four conductors between a desk set and the subscriber set that contained the telephone hybrid and a ringer. For this purpose, Bell System engineers developed a cube-shaped ...

  6. DMX512 - Wikipedia

    en.wikipedia.org/wiki/DMX512

    DMX512-A (ANSI E1.11-2008) defined the use of eight-pin modular (8P8C, or "RJ-45") connectors for fixed installations where regular plugging and unplugging of equipment is not required. Several manufacturers used other pinouts for RJ-45 connectors prior to this inclusion in the standard.

  7. Phone connector (audio) - Wikipedia

    en.wikipedia.org/wiki/Phone_connector_(audio)

    Hands-free sets and headsets often use 3.5 mm or 2.5 mm connectors. TRS connectors are used for mono audio out and an unbalanced microphone (with a shared ground). Four-conductor TRRS phone connectors add an additional audio channel for stereo output.

  8. IEC metric screw sized connectors - Wikipedia

    en.wikipedia.org/wiki/IEC_metric_screw_sized...

    IEC metric screw sized connectors is a family of electrical connectors defined by IEC that are named according to their ISO metric screw thread, namely M5, M8 and M12. [1] The number gives their outer screw thread diameter in millimeters as with the identically named screws.

  9. GG45 - Wikipedia

    en.wikipedia.org/wiki/GG45

    GG45 is a variant of ARJ45 that allows for cables terminated with male 8P8C (AKA RJ45) connectors to be plugged into GG45 jacks. However, GG45 cables cannot plug into 8P8C jacks as a protrusion on the socket is designed to activate a switch on the jack for the alternative contact positions. [2]