Search results
Results from the WOW.Com Content Network
A graphical or bar scale. A map would also usually give its scale numerically ("1:50,000", for instance, means that one cm on the map represents 50,000cm of real space, which is 500 meters) A bar scale with the nominal scale expressed as "1:600 000", meaning 1 cm on the map corresponds to 600,000 cm=6 km on the ground.
Most zones in UTM span 6 degrees of longitude, and each has a designated central meridian. The scale factor at the central meridian is specified to be 0.9996 of true scale for most UTM systems in use. [1] [2] UTM zones on an equirectangular world map with irregular zones in red and New York City's zone highlighted
The scale: parameter specifies the desired map scale as 1:N, overriding the scale implied by any type: parameter. GeoHack uses scale: to select a map scale for a 72 dpi computer monitor. If no dim:, type:, or scale: parameters are provided, GeoHack uses its default scale of 1:300,000.
For example, a Mercator map printed in a book might have an equatorial width of 13.4 cm corresponding to a globe radius of 2.13 cm and an RF of approximately 1 / 300M (M is used as an abbreviation for 1,000,000 in writing an RF) whereas Mercator's original 1569 map has a width of 198 cm corresponding to a globe radius of 31.5 cm and an ...
The formulas involved can be complex and in some cases, such as in the ECEF to geodetic conversion above, the conversion has no closed-form solution and approximate methods must be used. References such as the DMA Technical Manual 8358.1 [15] and the USGS paper Map Projections: A Working Manual [16] contain formulas for conversion of map ...
The projection is reasonably accurate near the equator. Scale at an angular distance of 5° (in latitude) away from the equator is less than 0.4% greater than scale at the equator, and is about 1.54% greater at an angular distance of 10°. • The projection is reasonably accurate near the central meridian.
In most European countries, the largest scale topographic map series is a 1:25.000 scale series. Notable exceptions are Austria (1:50,000) and Finland (1:20,000). Many non-European states limit the largest scale of their map series, usually to 1:50,000 scale, frequently due to the large size of the country covered (and hence for financial reasons).
The length of the line on the linear scale is equal to the distance represented on the earth multiplied by the map or chart's scale. In most projections, scale varies with latitude, so on small scale maps, covering large areas and a wide range of latitudes, the linear scale must show the scale for the range of latitudes covered by the map. One ...