Search results
Results from the WOW.Com Content Network
Material removal rate (MRR) is the amount of material removed per time unit (usually per minute) when performing machining operations such as using a lathe or milling machine. The more material removed per minute, the higher the material removal rate. [1] [2] The MRR is a single number that enables you to do this. It is a direct indicator of ...
[6] [7] An equation giving the material removal rate for an electrochemical grinding process is provided in [5] and is stated here as: MRR = GI/ρF [5] where ρ is the workpiece density, G is the total mass of the workpiece, I is the current supplied, MRR is the material removal rate, and F is Faraday's constant. [5]
The needed current is proportional to the desired rate of material removal, and the removal rate in mm/minute is proportional to the amps per square mm. Typical currents range from 0.1 amp per square mm to 5 amps per square mm. Thus, for a small plunge cut of a 1 by 1 mm tool with a slow cut, only 0.1 amps would be needed.
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.
The stock removal rate is largely a function of the material's properties. This is expressed as the machinability of a material: the ease or difficulty of machining a particular material. The machinability of materials varies greatly; for instance, aluminium and magnesium have high machinability compared to titanium and other special metals.
Can be described using the Tool Life Expectancy equation. crater wear in which contact with chips erodes the rake face. This is somewhat normal for tool wear, and does not seriously degrade the use of a tool until it becomes serious enough to cause a cutting edge failure. Can be caused by spindle speed that is too low or a feed rate that is too ...
Yahoo faz parte da família de marcas Yahoo. O Yahoo coletará e usará seus dados como parte dos serviços oferecidos, para entender seus interesses e oferecer e mensurar anúncios personalizados.
In this case, the cutter is always in contact with the work material. Hence the idle time spent in positioning and retracting the tool is avoided. For large-scale material removal, contour-parallel tool path is widely used because it can be consistently used with up-cut or down-cut method during the entire process.