Search results
Results from the WOW.Com Content Network
Adhesion – the attraction of molecules or compounds for other molecules of a different kind; Specific heat capacity – the amount of heat needed to raise the temperature of one gram of a substance by one degree Celsius; Heat of vaporization – the amount of energy needed to change one gram of a liquid substance to a gas at constant temperature
The reverse process accounts for the fog burning off in the morning. If the humidity is increased at room temperature, for example, by running a hot shower or a bath, and the temperature stays about the same, the vapor soon reaches the pressure for phase change and then condenses out as minute water droplets, commonly referred to as steam.
The pressure on a pressure-temperature diagram (such as the water phase diagram shown above) is the partial pressure of the substance in question. A phase diagram in physical chemistry , engineering , mineralogy , and materials science is a type of chart used to show conditions (pressure, temperature, etc.) at which thermodynamically distinct ...
A typical phase diagram.The solid green line applies to most substances; the dashed green line gives the anomalous behavior of water. In thermodynamics, the triple point of a substance is the temperature and pressure at which the three phases (gas, liquid, and solid) of that substance coexist in thermodynamic equilibrium. [1]
P v ° is the standard vapor pressure for that liquid at that temperature and pressure. V is the molar volume. R is the gas constant; r k is the Kelvin radius, the radius of the droplets. The effect explains supersaturation of vapors. In the absence of nucleation sites, tiny droplets must form before they can evolve into larger droplets.
Cohesion causes water to form drops, surface tension causes them to be nearly spherical, and adhesion keeps the drops in place. Water droplets are flatter on a Hibiscus flower which shows better adhesion. In surface science, the term adhesion almost always refers to dispersive adhesion.
This occurs between water and glass. Water-based fluids like sap, honey, and milk also have a concave meniscus in glass or other wettable containers. Conversely, a convex meniscus occurs when the adhesion energy is less than half the cohesion energy. Convex menisci occur, for example, between mercury and glass in barometers [1] and thermometers.
In thermodynamics, the Joule–Thomson effect (also known as the Joule–Kelvin effect or Kelvin–Joule effect) describes the temperature change of a real gas or liquid (as differentiated from an ideal gas) when it is expanding; typically caused by the pressure loss from flow through a valve or porous plug while keeping it insulated so that no heat is exchanged with the environment.