Search results
Results from the WOW.Com Content Network
Dimensions of a square thread form. The square thread form is a common screw thread profile, used in high load applications such as leadscrews and jackscrews. It gets its name from the square cross-section of the thread. [1] It is the lowest friction and most efficient thread form, but it is difficult to fabricate.
Typical O-ring and application. An O-ring, also known as a packing or a toric joint, is a mechanical gasket in the shape of a torus; it is a loop of elastomer with a round cross-section, designed to be seated in a groove and compressed during assembly between two or more parts, forming a seal at the interface.
Original file (1,091 × 1,108 pixels, file size: 15 KB, MIME type: application/pdf) This is a file from the Wikimedia Commons . Information from its description page there is shown below.
A single-cut file has one set of parallel teeth while a cross-cut or double-cut file has a second set of cuts forming diamond shaped cutting surfaces. [1] In Swiss-pattern files the teeth are cut at a shallower angle, and are graded by number, with a number 1 file being coarser than a number 2, etc.
In the modern standard metric version, it is simply a size number, where listed diameter size is the major outer diameter of the external thread. For a taper thread, it is the diameter at the "gauge length" (plus/minus one thread pitch) from the small end of the thread.
A Robertson screw, also known as a square screw [1] or Scrulox, [2] is a type of screw with a square-shaped socket in the screw head and a corresponding square protrusion on the tool. Both the tool and socket have a slight taper .
The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than 1 / 4 inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.
The Acme thread was developed in 1894 as a profile well suited to power screws that has various advantages over the square thread, [note 1] which had been the form of choice until then. It is easier to cut with either single-point threading or die than the square thread is (because the latter's shape requires tool bit or die tooth geometry that ...