Search results
Results from the WOW.Com Content Network
An alternative technique used a similar scheme to the above except that the connections of two of the lamps were swapped either at the generator terminals or the system terminals. In this scheme, when the generator was in synchronism with the system, one lamp would be dark, but the two with the swapped connections would be of equal brightness.
This synchroscope was used to synchronize a factory's power plant with the utility's power grid. In AC electrical power systems, a synchroscope is a device that indicates the degree to which two systems (generators or power networks) are synchronized with each other. [1]
In a synchronous generator, [1] the short circuit ratio is the ratio of field current required to produce rated armature voltage at the open circuit to the field current required to produce the rated armature current at short circuit. [1] [2] This ratio can also be expressed as an inverse of the saturated [3] direct-axis synchronous reactance ...
[citation needed] In a traditional grid dominated by synchronous generators, a strong grid with SCR greater than 3.0 will have the desired voltage stability and active power reserves. [4] A weak grid (with SCR values between 2.0 and 3.0 [6]) can exhibit voltage instability and control problems. [5] A grid with SCR below 2.0 is very weak. [6]
In movie and television production it is necessary to synchronize video frames from multiple cameras. In addition to enabling basic editing, synchronization can also be used for 3D reconstruction [31] In electric power systems, alternator synchronization is required when multiple generators are connected to an electrical grid.
An electrical grid may have many types of generators and loads; generators must be controlled to maintain stable operation of the system. In an electric power system, automatic generation control (AGC) is a system for adjusting the power output of multiple generators at different power plants, in response to changes in the load. Since a power ...
The important point in modeling synchronverter is to be sure that it has similar dynamic behavior to Synchronous generator (see figure 3). This model is classified into 2-order up to 7-order model, due to its complexity. However, 3-order model is widely used because of proper compromise between accuracy and complexity. [14] = (+.) +.
Generator locking can be used to synchronize as few as two isolated sources (e.g., a television camera and a videotape machine feeding a vision mixer (production switcher)), or in a wider facility where all the video sources are locked to a single synchronizing pulse generator (e.g., a fast-paced sporting event featuring multiple cameras and recording devices).