Search results
Results from the WOW.Com Content Network
When cascading flip-flops which share the same clock (as in a shift register), it is important to ensure that the t CO of a preceding flip-flop is longer than the hold time (t h) of the following flip-flop, so data present at the input of the succeeding flip-flop is properly "shifted in" following the active edge of the clock.
Here, the contamination delay is the amount of time needed for a change in the flip-flop clock input to result in the initial change at the flip-flop output (Q). If there is insufficient delay from the output of the first flip-flop to the input of the second, the input may change before the hold time has passed. Because the second flip-flop is ...
An asynchronous (ripple) counter is a "chain" of toggle (T) flip-flops in which the least-significant flip-flop (bit 0) is clocked by an external signal (the counter input clock), and all other flip-flops are clocked by the output of the nearest, less significant flip-flop (e.g., bit 0 clocks the bit 1 flip-flop, bit 1 clocks the bit 2 flip ...
If the output of the flip-flop is low, and a high clock pulse is applied with the input being a low pulse, then there is no need for a state transition. The extra computation to sample the inputs cause an increase in setup time of the flip-flop; this is a disadvantage of this technique. [3]
A shift register is a type of digital circuit using a cascade of flip-flops where the output of one flip-flop is connected to the input of the next. They share a single clock signal, which causes the data stored in the system to shift from one location to the next.
When the input is below a different (lower) chosen threshold the output is low, and when the input is between the two levels the output retains its value. This dual threshold action is called hysteresis and implies that the Schmitt trigger possesses memory and can act as a bistable multivibrator (latch or flip-flop). There is a close relation ...
The Timing closure in VLSI design and electronics engineering is the process by which a logic design of a clocked synchronous circuit consisting of primitive elements such as combinatorial logic gates (AND, OR, NOT, NAND, NOR, etc.) and sequential logic gates (flip flops, latches, memories) is modified to meet its timing requirements.
D : Q; where Dff is the D-input of a D-type flip-flop, D is the module information input (without CE input), and Q is the D-type flip-flop output. This type of clock gating is race-condition-free and is preferred for FPGA designs. For FPGAs, every D-type flip-flop has an additional CE input signal.