Search results
Results from the WOW.Com Content Network
A 'power supply tester' is a tool used to test the functionality of a computer's power supply. Testers can confirm the presence of the correct voltages at each power supply connector. Testing under load is recommended for the most accurate readings. [44]
#PS_ON pin is marked by number 16. PS-ON Signal is a pin on a 20-pin or 24-pin ATX-specified power connector used to turn a personal computer power supply unit on/off. The PS_ON pin is normally pulled high in an open-circuit, but will turn on the power supply when it is pulled low, by shorting it to the common signal (COM).
The ATX specification defines the Power-Good signal as a +5-volt (V) signal generated in the power supply when it has passed its internal self-tests and the outputs have stabilized. This normally takes between 0.1 and 0.5 seconds after the power supply is switched on.
SFX-12V SFX12V – Power Supply Design Guide – Version 2.3, S. 19–23 English: PC Power Supply Unit Noise Test Setup. SFX-12V SFX12V – Power Supply Design Guide – Version 2.3, p. 19–23
A power-on self-test (POST) is a process performed by firmware or software routines immediately after a computer or other digital electronic device is powered on. [ 1 ] POST processes may set the initial state of the device from firmware and detect if any hardware components are non-functional.
The CPU core voltage (V CORE) is the power supply voltage supplied to the processing cores of CPU (which is a digital circuit), GPU, or any other device with a processing core. The amount of power a CPU uses, and thus the amount of heat it dissipates, is the product of this voltage and the current it draws.
Typically, dementia is associated with classic symptoms like confusion and memory loss. But new research finds that there could be a less obvious risk factor out there: your cholesterol levels ...
80 Plus (trademarked 80 PLUS) is a voluntary certification program launched in 2004, intended to promote efficient energy use in computer power supply units (PSUs). Certification is acquirable for products that have more than 80% energy efficiency at 20%, 50% and 100% of rated load, and a power factor of 0.9 or greater at 100% load.