Search results
Results from the WOW.Com Content Network
This derived distribution can be used to determine how often the difference in dimensions will be less than zero (i.e., the shaft cannot fit in the hole), how often the difference will be less than the required sliding gap (the shaft fits, but too tightly), and how often the difference will be greater than the maximum acceptable gap (the shaft ...
Indentation force-deflection is a process used in the flexible foam manufacturing industry to assess the "softness" of a sample of foam such as memory foam.To conduct an IFD test, a circular flat indenter with a surface area of 323 square centimeters (50 sq. inches - 8" in diameter) is pressed against a foam sample usually 100 mm thick and with an area of 500 mm by 500 mm (ASTM standard D3574).
The overlap coefficient, [note 1] or Szymkiewicz–Simpson coefficient, [citation needed] [3] [4] [5] is a similarity measure that measures the overlap between two finite sets.It is related to the Jaccard index and is defined as the size of the intersection divided by the size of the smaller of two sets:
Mesh is a measurement of particle size often used in determining the particle-size distribution of a granular material.For example, a sample from a truckload of peanuts may be placed atop a mesh with 5 mm openings.
“We tried a couple early on and weren’t able to convert them — tightly contested coverage,” he said. Allar spread his 12 completions to three tight ends and two running backs. To receivers ...
Dial indicator, also known as a dial test indicator, dial gauge, or probe indicator an instrument used to accurately measure small linear distances. Feeler gauge: a simple tool used to measure gap widths. Gauge block, (also known as a gage block, Johansson gauge, slip gauge, or Jo block) a precision ground and lapped length measuring standard.
The bird flu outbreak continues to grow in the U.S., with state officials confirming infected flocks in two additional Michigan counties on Monday. Following an investigation by the Michigan ...
The test was developed by Frederick Knoop [2] and colleagues at the National Bureau of Standards (now NIST) of the United States in 1939, and is defined by the ASTM E384 standard. The advantages of the test are that only a very small sample of material is required, and that it is valid for a wide range of test forces.