Search results
Results from the WOW.Com Content Network
Tacking or coming about is a sailing maneuver by which a sailing craft (sailing vessel, ice boat, or land yacht), whose next destination is into the wind, turns its bow toward and through the wind so that the direction from which the wind blows changes from one side of the boat to the other, allowing progress in the desired direction. [1]
However, under sail on a given tack, the corner to which the spinnaker sheet is attached is called the clew, and the corner attached to the spinnaker pole is referred to as the tack. [20] Tack – The tack is the corner on a fore-and-aft sail where the luff and foot connect [8] and, on a mainsail, is located where the boom and mast connect.
A tack is the windward side of a sailing craft (side from which the wind is coming while under way)—the starboard or port tack. Generally, a craft is on a starboard tack if the wind is coming over the starboard (right) side with sails on port (left) side. Similarly, a craft is on a port tack if the wind is coming over the port (left).
The jib is backed to windward, the mainsail is slightly eased, and the rudder is fixed in an attempt to turn into the wind (which is coming from the top of the diagram). In sailing, heaving to (to heave to and to be hove to) is a way of slowing a sailing vessel's forward progress, as well as fixing the helm and sail positions so that the vessel ...
The ship is close-hauled and the sail is now controlled by the tack rather than the sheet. The tack of a square-rigged sail is a line attached to its lower corner. [1] This is in contrast to the more common fore-and-aft sail, whose tack is a part of the sail itself, the corner which is (possibly semi-permanently) secured to the vessel.
A sail plan is a drawing of a sailing craft, viewed from the side, depicting its sails, the spars that carry them and some of the rigging that supports the rig. [1] By extension, "sail plan" describes the arrangement of sails on a craft. [2] [3] A sailing craft may be waterborne (a ship or boat), an iceboat, or a sail-powered land vehicle.
As the boat tacks they change over. Another function of the running backstay is to adjust the tension of the forestay to suit the sailing angle and sea condition. In general, during a hard beat when the boat sails very close to the wind, the running backstay is tightened to increase the tension of the forestay. The genoa is sheeted in.
Boats on a port tack shall keep clear of boats on starboard tack (Rule 10). When boats are on the same tack and overlapped, the boat to windward (the boat closest to the wind) shall keep clear of a leeward boat (Rule 11). When boats are on the same tack and not overlapped, the boat that is astern shall keep clear of the boat ahead. (Rule 12).