Search results
Results from the WOW.Com Content Network
In C and many derivative programming languages, a string escape sequence is a series of two or more characters, starting with a backslash \. [3]Note that in C a backslash immediately followed by a newline does not constitute an escape sequence, but splices physical source lines into logical ones in the second translation phase, whereas string escape sequences are converted in the fifth ...
Code points located at U+10000 or higher must be denoted with the \U syntax, whereas lower code points may use \u or \U. The code point is converted into a sequence of code units in the encoding of the destination type on the target system. For example, where the encoding is UTF-8, and UTF-16 for wchar_t:
Select a single character from one of the alternative character sets. SS2 selects the G2 character set, and SS3 selects the G3 character set. [13] In a 7-bit environment, this is followed by one or more GL bytes (0x20–0x7F) specifying a character from that set. [12]: 9.4 In an 8-bit environment, these may instead be GR bytes (0xA0–0xFF).
Generally, an escape character is not a particular case of (device) control characters, nor vice versa.If we define control characters as non-graphic, or as having a special meaning for an output device (e.g. printer or text terminal) then any escape character for this device is a control one.
For example, if the delimiter is a double quote, one cannot simply represent a double quote itself by the literal """ as the second quote is interpreted as the end of the string literal, not as the value of the string, and similarly one cannot write "This is "in quotes", but invalid."
There is another kind of character reference called a character entity reference, which allows a character to be referred to by a name instead of a number. (Naming a character creates a character entity.) HTML defines some character entities, but not many; all other characters can only be included by direct encoding or using NCRs.
The following simple example involves searching a two-dimensional table for a particular item. exitwhen found or missing; for I := 1 to N do for J := 1 to M do if table[I,J] = target then found; missing; exits found: print ("item is in table"); missing: print ("item is not in table"); endexit;
In 1973, ECMA-35 and ISO 2022 [18] attempted to define a method so an 8-bit "extended ASCII" code could be converted to a corresponding 7-bit code, and vice versa. [19] In a 7-bit environment, the Shift Out would change the meaning of the 96 bytes 0x20 through 0x7F [a] [21] (i.e. all but the C0 control codes), to be the characters that an 8-bit environment would print if it used the same code ...