enow.com Web Search

  1. Ads

    related to: phillips head #00 screwdriver bits

Search results

  1. Results from the WOW.Com Content Network
  2. List of screw drives - Wikipedia

    en.wikipedia.org/wiki/List_of_screw_drives

    One advantage over the Phillips drive is that one driver or bit fits all screw sizes. It is often found in marine hardware and requires a Frearson screwdriver or bit to work properly. The tool recess is a perfect, sharp cross, allowing for higher applied torque, unlike the rounded, tapered Phillips head, which can cam out at high torque. It was ...

  3. Henry F. Phillips - Wikipedia

    en.wikipedia.org/wiki/Henry_F._Phillips

    Phillips screw head. Henry Frank Phillips (June 4, 1889 – April 13, 1958) was an American businessman from Portland, Oregon. The Phillips-head ("crosshead") screw and screwdriver are named after him. [1] The importance of the crosshead screw design lies in its self-centering property, useful on automated production lines that use powered ...

  4. Robertson screw - Wikipedia

    en.wikipedia.org/wiki/Robertson_screw

    Many screws used in electrical applications (for example, a typical NEMA 5-15R, breaker screws, and conduit screws) use a combination of a slotted/Phillips/Robertson screw head. A few tool manufacturers make bits to engage this screw head better than the traditional Phillips allowing for more torque before camout, for example, the C1 and C2 ...

  5. Screwdriver - Wikipedia

    en.wikipedia.org/wiki/Screwdriver

    The tool used to drive a slotted screw head is called a standard, common blade, flat-blade, slot-head, straight, flat, flat-tip, [6] or "flat-head" [7] screwdriver. This last usage can be confusing, because the term flat-head also describes a screw with a flat top, designed to install in a countersunk hole. Before the development of the newer ...

  6. Cam out - Wikipedia

    en.wikipedia.org/wiki/Cam_out

    Cam out (also cam-out or camming out) is a process by which a screwdriver slips out of the head of a screw being driven once the torque required to turn the screw exceeds a certain amount. [1] Repeatedly camming out damages the screw, and possibly also the screwdriver, and should normally be avoided.

  7. Pentalobe screw - Wikipedia

    en.wikipedia.org/wiki/Pentalobe_screw

    At first, #00 Phillips screws were used, but later iPhone 4 models had pentalobe screws. [9] The screws used were slightly smaller than a Torx TS1, about 0.8 mm. If brought in to an Apple Store for repair, iPhone 4 models with #00 Phillips screws, if any, were replaced with 0.8 mm pentalobe screws. [ 10 ]

  1. Ads

    related to: phillips head #00 screwdriver bits