Search results
Results from the WOW.Com Content Network
The centre of a shaft is not toothed, as this would add little torque capacity to the coupling and the increasingly narrow teeth would become impractical to cut. For instance, a shaft of 60 mm diameter can be toothed in a 12 mm wide ring only (inner diameter is 36 mm) without jeopardizing the load-bearing capacity of the shaft.
A drive shaft system weighs more than a chain system, usually 0.5–1 kg (1–2 lb) heavier. Many of the advantages claimed by drive shaft's proponents can be achieved on a chain-driven bicycle, such as covering the chain and sprockets. Use of lightweight derailleur gears with a high number of ratios is impossible, although hub gears can be used.
A split shaft PTO is mounted to the truck's drive shaft to provide power to the PTO. Such a unit is an additional gearbox that separates the vehicle's drive shaft into two parts: The gearbox-facing shaft which will transmit the power of the engine to the split shaft PTO; The axle-facing shaft which transmit the propelling power to the axle.
Hypoid spiral bevel gears. A hypoid is a type of spiral bevel gear whose axis does not intersect with the axis of the meshing gear. The shape of a hypoid gear is a revolved hyperboloid (that is, the pitch surface of the hypoid gear is a hyperbolic surface), whereas the shape of a spiral bevel gear is normally conical.
A spline is a ridge or tooth [1] [2] [3] on a drive shaft that matches with a groove in a mating piece and transfers torque to it, maintaining the angular correspondence between them. For instance, a gear mounted on a shaft might use a male spline on the shaft that matches the female spline on the gear.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
RR layout. In automotive design, an RR, or rear-engine, rear-wheel-drive layout places both the engine and drive wheels at the rear of the vehicle. In contrast to the RMR layout, the center of mass of the engine is between the rear axle and the rear bumper.
An alternate mechanism is to clamp a lever to the shaft and measure using a single balance. The torque is then related to the lever length, shaft diameter and measured force. The device is generally used over a range of engine speeds to obtain power and torque curves for the engine, since there is a non-linear relationship between torque and ...