Search results
Results from the WOW.Com Content Network
Vertical, metal furring is applied to the wall to create a channel and receive the siding material. In construction, furring (furring strips) are strips of wood or other material applied to a structure to level or raise the surface, to prevent dampness, to make space for insulation, to level and resurface ceilings or walls, [1] or to increase the beam of a wooden ship.
This is a list of insulation materials used around the world. Typical R-values are given for various materials and structures as approximations based on the average of available figures and are sorted by lowest value. R-value at 1 m gives R-values normalised to a 1 metre (3 ft 3 in) thickness and sorts by median value of the range.
EPS is the most common of the foams used and has an R-value (thermal resistance) of about 4 °F·ft 2 ·h/Btu (equivalent to about 0.7 K·m 2 /W) per 25 mm thickness, which would give the 3.5 inches (89 mm) of foam in a 4.5-inch-thick (110 mm) panel an R value of 13.8 (caution: extrapolating R-values over thickness may be imprecise due to non ...
Battens are also used in metal roofing to secure the sheets called a batten-seam roof and are covered with a batten roll joint. [2] Some roofs may use a grid of battens in both directions, known as a counter-batten system, which improves ventilation. Roofing battens are most commonly made of wood or metal, but can be made of other materials.
Insulation is a barrier material to resist/reduce substance (water, vapor, etc. ) /energy (sound, heat, electric, etc.) to transfer from one side to another. Heat/ Thermal Insulation is a barrier material to resist / block / reflect the heat energy (either one or more of the Conduction, Convection or Radiation) to transfer from one side to another.
The Energy Saving Ordinance (EnEV) 2013 clarified the requirement of thermal insulation of the ceiling. And it mentioned that if the ceiling was not fulfilled, thermal insulation will be needed in accessible ceilings over upper floor's heated rooms. [U-Value must be under 0.24 W/(m 2 ⋅K)] [32]
The density of sandwich panels range from 10 kg/m 2 up to 35 kg/m 2, depending on the foam and metal thickness, decreasing time and effort in: transportation, handling and installation. All these geometric and material properties influence the global/local failure behavior of the sandwich panels under different loading conditions such as ...
When thickness less than or equal to 3/16" (4.76mm): The various possible welds in cold formed steel sections, where the thickness of the thinnest element in the connection is 3/16" or less are as follows Groove Welds in Butt joints; Arc Spot Welds; Arc Seam Welds; Fillet Welds; Flare Groove Welds; 2.When thickness greater than or equal to 3/16 ...