Ad
related to: feed check valve in boiler drain pump troubleshootingsupplyhouse.com has been visited by 100K+ users in the past month
- Expansion Tanks
Protect Systems With Tanks From
Amtrol, Bell & Gossett, & More.
- Heat Exchangers
Shop the Top Heat Exchangers
at the Lowest Prices Online.
- Boilers
Find High Efficiency and Standard
Boilers Perfect for the Job.
- Circulator Pumps
Shop Our Selection of Pumps Today.
Top Brands, Low Prices.
- Expansion Tanks
Search results
Results from the WOW.Com Content Network
A duplex steam pump has two sets of steam and water cylinders. They are not physically connected but the steam valves on the first pump are operated by the movement of the second pump's piston rod, and vice versa. The result is that there are no "dead spots" and the pump is always self-starting. [2]
Many similar pump-like mechanisms for moving volumes of fluids around use check valves such as ball check valves. The feed pumps or injectors which supply water to steam boilers are fitted with check valves to prevent back-flow. Check valves are also used in the pumps that supply water to water slides. The water to the slide flows through a ...
Boiler feedwater is the water which is supplied to a boiler. The feed water is put into the steam drum from a feed pump. In the steam drum the feed water is then turned into steam from the heat. After the steam is used, it is then dumped to the main condenser. From the condenser, it is then pumped to the deaerated feed tank.
See also priming. Check valve Clack valve Clack from the noise it makes. A non-return valve where the feedwater enters the boiler drum. They are usually mounted halfway along the boiler drum, or else as a top feed, but away from the firebox, so as to avoid stressing it with the shock of cold water.
A tempering valve mixes enough cold water with the hot water from the heater to keep the outgoing water temperature fixed at a more moderate temperature, often set to 50 °C (122 °F). Without a tempering valve, reduction of the water heater's setpoint temperature is the most direct way to reduce scalding.
Several short blowdown events remove sludge more effectively than a single continuous blowdown. Shorter blowdown events cause less significant changes in boiler water level, and are safer during periods of high steam demand. [5] Bottom blowdown piping drains the lowest parts of the boiler so it can be used to drain the boiler for servicing.
If this vent valve has not be opened sufficiently, the deaerator will not work properly, resulting in feed water with a high oxygen content going to the boilers. Should the boiler not have an oxygen-content analyzer, a high level in the boiler chlorides may indicate the vent valve not being far enough open.
Feedwater check valve or clack valve: A non-return stop valve in the feedwater line. This may be fitted to the side of the boiler, just below the water level, or to the top of the boiler. [13] Top feed: In this design for feedwater injection, the water is fed to the top of the boiler. This can reduce boiler fatigue caused by thermal stress.
Ad
related to: feed check valve in boiler drain pump troubleshootingsupplyhouse.com has been visited by 100K+ users in the past month