Search results
Results from the WOW.Com Content Network
A very simple equivalence testing approach is the ‘two one-sided t-tests’ (TOST) procedure. [11] In the TOST procedure an upper (Δ U) and lower (–Δ L) equivalence bound is specified based on the smallest effect size of interest (e.g., a positive or negative difference of d = 0.3).
In null-hypothesis significance testing, the p-value [note 1] is the probability of obtaining test results at least as extreme as the result actually observed, under the assumption that the null hypothesis is correct. [2] [3] A very small p-value means that such an extreme observed outcome would be very unlikely under the null hypothesis.
The Newman–Keuls procedure cannot produce a confidence interval for each mean difference, or for multiplicity adjusted exact p-values due to its sequential nature. [citation needed] Results are somewhat difficult to interpret since it is difficult to articulate what are the null hypotheses that were tested. [citation needed]
Under Fisher's method, two small p-values P 1 and P 2 combine to form a smaller p-value.The darkest boundary defines the region where the meta-analysis p-value is below 0.05.. For example, if both p-values are around 0.10, or if one is around 0.04 and one is around 0.25, the meta-analysis p-value is around 0
The weighted harmonic mean of p-values , …, is defined as = = = /, where , …, are weights that must sum to one, i.e. = =.Equal weights may be chosen, in which case = /.. In general, interpreting the HMP directly as a p-value is anti-conservative, meaning that the false positive rate is higher than expected.
The interpretation of a p-value is dependent upon stopping rule and definition of multiple comparison. The former often changes during the course of a study and the latter is unavoidably ambiguous. (i.e. "p values depend on both the (data) observed and on the other possible (data) that might have been observed but weren't"). [69]
The p-value is not the probability that the observed effects were produced by random chance alone. [2] The p-value is computed under the assumption that a certain model, usually the null hypothesis, is true. This means that the p-value is a statement about the relation of the data to that hypothesis. [2]
The binomial distribution is the basis for the p-chart and requires the following assumptions: [2]: 267 The probability of nonconformity p is the same for each unit; Each unit is independent of its predecessors or successors; The inspection procedure is the same for each sample and is carried out consistently from sample to sample