Search results
Results from the WOW.Com Content Network
Capacity utilization or capacity utilisation is the extent to which a firm or nation employs its installed productive capacity (maximum output of a firm or nation). It is the relationship between output that is produced with the installed equipment, and the potential output which could be produced with it, if capacity was fully used. [1]
This is related to an activity rate which is a similar calculation used in activity-based costing. A pre-determined overhead rate is normally the term when using a single, plant-wide base to calculate and apply overhead. Overhead is then applied by multiplying the pre-determined overhead rate by the actual driver units. Any difference between ...
The calculation for the output gap is (Y–Y*)/Y* where Y is actual output and Y* is potential output. If this calculation yields a positive number it is called an inflationary gap and indicates the growth of aggregate demand is outpacing the growth of aggregate supply—possibly creating inflation; if the calculation yields a negative number it is called a recessionary gap—possibly ...
Typically, there is a high initial RPR during the early phases of development, then the RPR sharply declines toward the maximum level of production. Following to the production decline, the magnitude of the P/R ratio can either continue to decline, remain stable for some period of time, or increase, especially when a production slump occurs. [4]
The equation below (in Cobb–Douglas form) is often used to represent total output (Y) as a function of total-factor productivity (A), capital input (K), labour input (L), and the two inputs' respective shares of output (α and β are the share of contribution for K and L respectively).
In economics, a production function gives the technological relation between quantities of physical inputs and quantities of output of goods. The production function is one of the key concepts of mainstream neoclassical theories, used to define marginal product and to distinguish allocative efficiency, a key focus of economics. One important ...
This method is an extension of the economic order quantity model (also known as the EOQ model). The difference between these two methods is that the EPQ model assumes the company will produce its own quantity or the parts are going to be shipped to the company while they are being produced, therefore the orders are available or received in an ...
Variable costs (VC) are the costs of the variable input, labor, or wL, where w is the wage rate and L is the amount of labor employed. Thus, VC = wL. Marginal cost (MC) is the change in total cost per unit change in output or ∆C/∆Q. In the short run, production can be varied only by changing the variable input.