Search results
Results from the WOW.Com Content Network
This engine uses a MAF sensor to monitor manifold pressure, similar to the G16B series. This engine has a non-interference valvetrain design. It uses the same G series block found in many other Suzuki models and so it is a popular conversion into the Suzuki Sierra/Samurai, which uses either a G13A (85-88) or G13BA (88.5-98).
In sidevalve engines the head is a simple plate of metal containing the spark plugs and possibly heat dissipation fins. In more modern overhead valve and overhead camshaft engines, the head is a more complicated metal block that also contains the inlet and exhaust passages, and often coolant passages, Valvetrain components, and fuel injectors.
A petrol version of this modified engine was 'reverse-engineered' for use in the Mini Tractor whilst retaining parts commonality with the diesel variant, rather than using a standard petrol A-series unit. The diesel A series was also sold as a marine engine under the BMC name alongside the diesel B-series engines. Production ceased in 1969.
The LT1 uses a new engine block, cylinder head, timing cover, water pump, intake manifold and accessory brackets. The harmonic damper also does not interchange; it is a unique damper/pulley assembly. Engine mounts and bell housing bolt pattern remain the same, permitting a newer engine to be readily swapped into an older vehicle.
A crossflow head gives better performance than a Reverse-flow cylinder head (though not as good as a uniflow), but the popular explanation put forward for this — that the gases do not have to change direction and hence are moved into and out of the cylinder more efficiently — is a simplification since there is no continuous flow because of valve opening and closing.
The W-series engine was made of cast iron. The engine block had 4.84-inch (123 mm) bore centers, two-bolt main bearing caps, a "side oiling" lubrication system (the main oil gallery located low on the driver's side of the crankcase), with full-flow oil filter, and interchangeable cylinder heads. Heads used on the high performance 409 and 427 ...
The 4.8L and the 5.3L are smaller truck versions of the LS1 and were designed to replace the 305 and the 350 in trucks. The 4.8L and 5.3L engines share the same Gen III LS-series engine block and heads (upper end) and therefore, most parts interchange freely between these engines and other variants in the LS family.
A cylinder head of a four valve Nissan VQ engine engine. A multi-valve or multivalve engine is one where each cylinder has more than two valves (an intake, and an exhaust).A multi-valve engine has better breathing, and with more smaller valves (having less mass in motion) may be able to operate at higher revolutions per minute (RPM) than a two-valve engine, delivering more power.