Search results
Results from the WOW.Com Content Network
MIL-STD-498 standard describes the development and documentation in terms of 22 Data Item Descriptions (DIDs), which were standardized documents for recording the results of each the development and support processes, for example, the Software Design Description DID was the standard format for the results of the software design process.
MIL-STD 461, "Requirements for the control of electromagnetic interference characteristics of subsystems and equipment" [18] MIL-STD-464, "Electromagnetic Environmental Effects Requirements for Systems" [19] MIL-STD-498, on software development and documentation [20] MIL-STD-499, on Engineering Management (System Engineering)
A MIL-DTL-38999 circular connector plated with a nickel–teflon composite. Left: plug (male) type connector; Right: receptacle (female) type connector) Electrical or fiber-optic connectors used by U.S. Department of Defense were originally developed in the 1930s for severe aeronautical and tactical service applications, and the Type "AN" series set the standard for modern military circular ...
Succeeded by. MIL-STD-498. RTCA DO-178. DOD-STD-2167A (Department of Defense Standard 2167A), titled "Defense Systems Software Development", was a United States defense standard, published on February 29, 1988, which updated the less well known DOD-STD-2167 published 4 June 1985. This document established "uniform requirements for the software ...
It is preferred that articles in this category be listed by publishing identifier (MIL-STD-####) for consistency. Pages in category "Military of the United States standards" The following 46 pages are in this category, out of 46 total.
A United States data item description (DID) is a completed document defining the data deliverables required of a United States Department of Defense contractor. [1] A DID specifically defines the data content, format, and intended use of the data with a primary objective of achieving standardization objectives by the U.S. Department of Defense.
This standard codified information from, among other sources, a United States military standard MIL-STD-16 which dates back to at least the 1950s in American industry. To replace IEEE 200-1975, ASME, a standards body for mechanical engineers, initiated the new standard ASME Y14.44-2008. This standard, along with IEEE 315-1975, provide the ...
The Joint Electronics Type Designation System (JETDS), which was previously known as the Joint Army-Navy Nomenclature System (AN System. JAN) and the Joint Communications-Electronics Nomenclature System, is a method developed by the U.S. War Department during World War II for assigning an unclassified designator to electronic equipment.