Search results
Results from the WOW.Com Content Network
Vehicle emissions control is the study of reducing the emissions produced by motor vehicles, especially internal combustion engines. The primary emissions studied include hydrocarbons, volatile organic compounds, carbon monoxide, carbon dioxide, nitrogen oxides, particulate matter, and sulfur oxides.
Most engines require one or more systems to start and shut down the engine and to control parameters such as the power, speed, torque, pollution, combustion temperature, and efficiency and to stabilise the engine from modes of operation that may induce self-damage such as pre-ignition. Such systems may be referred to as engine control units.
The PCV system was designed to re-circulate the gases into the air intake so that they could be combined with the fresh air/fuel and get more completely combusted. In 1961, California regulations required that all new cars be sold with a PCV system, therefore representing the first implementation of a vehicle emissions control device. [6]
A three-way catalytic converter on a gasoline-powered 1996 Dodge Ram Simulation of flow inside a catalytic converter. A catalytic converter is an exhaust emission control device which converts toxic gases and pollutants in exhaust gas from an internal combustion engine into less-toxic pollutants by catalyzing a redox reaction.
This is a list of auto parts, which are manufactured components of automobiles. This list reflects both fossil-fueled cars (using internal combustion engines) and electric vehicles; the list is not exhaustive. Many of these parts are also used on other motor vehicles such as trucks and buses.
From 1976 through 1989, Chrysler equipped many vehicles with their Electronic Lean-Burn (ELB) system, which consisted of a spark control computer and various sensors and transducers. The computer adjusted spark timing based on manifold vacuum, engine speed, engine temperature, throttle position over time, and incoming air temperature.
1995 Cadillac Seville disengaged emissions controls whenever heat or air conditioning was on. In 1995, General Motors was ordered to recall 470,000 model year 1991 through 1995 Cadillacs and pay an $11 million fine for programming the car's electronic control unit (ECU) to enrich the fuel mixture any time the car's air conditioning or cabin heat was operating, since the EPA tests are conducted ...
MCA-Jet was a simpler system that sent the same air/fuel mixture to all intake and MCA-Jet valves. Each MCA-Jet valve is quite small and may be prone to carbon build-up, causing the MCA-Jet valve(s) to stick open. If a Mitsubishi-designed engine has low compression, the MCA-Jet valve(s) could be the cause.