enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Radio Resource Control - Wikipedia

    en.wikipedia.org/wiki/Radio_Resource_Control

    The Radio Resource Control (RRC) protocol is used in UMTS, LTE and 5G on the Air interface. It is a layer 3 (Network Layer) protocol used between UE and Base Station. This protocol is specified by 3GPP in TS 25.331 [2] for UMTS, in TS 36.331 [3] for LTE and in TS 38.331 [4] for 5G New Radio. RRC messages are transported via the PDCP-Protocol.

  3. Radio Network Controller - Wikipedia

    en.wikipedia.org/wiki/Radio_Network_Controller

    The Radio Network Controller (RNC) is a governing element in the UMTS radio access network and is responsible for controlling the Node Bs that are connected to it. The RNC carries out radio resource management, some of the mobility management functions and is the point where encryption is done before user data is sent to and from the mobile.

  4. Radio Bearer in UMTS - Wikipedia

    en.wikipedia.org/wiki/Radio_Bearer_in_UMTS

    In mobile telephony a bearer service is a link between two points, which is defined by a certain set of characteristics. Whenever user equipment (UE) is being provided with any service (CS/PS service), the service has to be associated with a Radio Bearer specifying the configuration for layer 2 and physical layer in order to have its QoS clearly defined.

  5. Packet Data Convergence Protocol - Wikipedia

    en.wikipedia.org/wiki/Packet_Data_Convergence...

    Packet Data Convergence Protocol (PDCP) is specified by 3GPP in TS 25.323 [1] for UMTS, TS 36.323 [2] for LTE and TS 38.323 [3] for 5G. PDCP is located in the Radio Protocol Stack in the UMTS/LTE/5G air interface on top of the RLC layer. PDCP provides its services to the RRC and user plane upper layers, e.g. IP at the UE or to the relay at the ...

  6. Radio resource management - Wikipedia

    en.wikipedia.org/wiki/Radio_Resource_Management

    Dynamic RRM schemes adaptively adjust the radio network parameters to the traffic load, user positions, user mobility, quality of service requirements, base station density, etc. Dynamic RRM schemes are considered in the design of wireless systems, in view to minimize expensive manual cell planning and achieve "tighter" frequency reuse patterns, resulting in improved system spectral efficiency.

  7. IMT-2020 - Wikipedia

    en.wikipedia.org/wiki/IMT-2020

    The following parameters are the requirements for IMT-2020 5G candidate radio access technologies. [6] Note that these requirements are not intended to restrict the full range of capabilities or performance that candidate for IMT-2020 might achieve, nor are they intended to describe how the technologies might perform in actual deployments.

  8. Troubleshoot a dial-up connection - AOL Help

    help.aol.com/articles/troubleshooting-a-dial-up...

    An active internet connection is required to be able to access all the best that America Online® offers. If you're using dial-up internet and can't connect, try the following troubleshooting steps: Check the dial tone - If you DO have one, it's likely the problem has something to do with your computer. If you DON'T, it's likely the problem has ...

  9. Reconfigurability - Wikipedia

    en.wikipedia.org/wiki/Reconfigurability

    In the context of Control reconfiguration, a field of fault-tolerant control within control engineering, reconfigurability is a property of faulty systems meaning that the original control goals specified for the fault-free system can be reached after suitable control reconfiguration.