Search results
Results from the WOW.Com Content Network
When a program wants to time its own operation, it can use a function like the POSIX clock() function, which returns the CPU time used by the program. POSIX allows this clock to start at an arbitrary value, so to measure elapsed time, a program calls clock(), does some work, then calls clock() again. [1] The difference is the time needed to do ...
Further, a "cumulative clock rate" measure is sometimes assumed by taking the total cores and multiplying by the total clock rate (e.g. a dual-core 2.8 GHz processor running at a cumulative 5.6 GHz). There are many other factors to consider when comparing the performance of CPUs, like the width of the CPU's data bus , the latency of the memory ...
To get better CPI values with pipelining, there must be at least two execution units. For example, with two executions units, two new instructions are fetched every clock cycle by exploiting instruction-level parallelism, therefore two different instructions would complete stage 5 in every clock cycle and on average the number of clock cycles ...
The resolution of an implementation's measurement of time does not imply the same precision of such measurements. For example, a system might return the current time as a value measured in microseconds, but actually be capable of discerning individual clock ticks with a frequency of only 100 Hz (10 ms).
Instructions per second (IPS) is a measure of a computer's processor speed. For complex instruction set computers (CISCs), different instructions take different amounts of time, so the value measured depends on the instruction mix; even for comparing processors in the same family the IPS measurement can be problematic.
Profilers interrupt program execution to collect information, which may result in a limited resolution in the time measurements, which should be taken with a grain of salt. Basic block profilers report a number of machine clock cycles devoted to executing each line of code, or a timing based on adding these together; the timings reported per ...
time (Unix) - can be used to determine the run time of a program, separately counting user time vs. system time, and CPU time vs. clock time. [1] timem (Unix) - can be used to determine the wall-clock time, CPU time, and CPU utilization similar to time (Unix) but supports numerous extensions.
One millionth of a second. Symbol is μs millisecond: 10 −3 s: One thousandth of a second. Shortest time unit used on stopwatches. jiffy (electronics) ~ 10 −3 s: Used to measure the time between alternating power cycles. Also a casual term for a short period of time. centisecond: 10 −2 s: One hundredth of a second. decisecond: 10 −1 s ...