Search results
Results from the WOW.Com Content Network
Aqueous or solvent cleaning both have accepted methods to dispose of the "sludge" created. It has been reported that talcum powder can be used as an absorbent of cosmoline by packing the powder around the item to be cleaned and applying sufficient heat to melt the solid film, allowing the compound to be wicked from the coated surface into the ...
It is important to remove grease or oil contamination prior to blast cleaning. Solvent cleaning, burn-off, etc., are commonly used for this purpose. In the blast cleaning process, compressed air (90 to 110 psi/610 to 760 kPa) is used to force an abrasive onto the surface to be cleaned.
Solvent degreasing is a process used to prepare a part for further operations such as electroplating or painting. Typically it uses petroleum , chlorine , dry ice or alcohol based solvents to dissolve the machining fluids and other contaminants that might be on the part.
It was first invented in 1955 by H.B. Sargent, R.M. Poorman and H. Lamprey and is applied to a component using a specifically designed detonation gun (D-gun). The component being sprayed must be prepared correctly by removing all surface oils, greases, debris and roughing up the surface in order to achieve a strongly bonded detonation spray ...
Cleaning agents or hard-surface cleaners are substances (usually liquids, powders, sprays, or granules) used to remove dirt, including dust, stains, foul odors, and clutter on surfaces. [1] Purposes of cleaning agents include health , beauty, removing offensive odors, and avoiding the spread of dirt and contaminants to oneself and others.
Parts washers were originally developed for use in automotive transmission and engine repair shops as a way to improve the function of simple soak tanks.Soak tanks are vats filled with a mixture of water and detergent, which take hours to "soften" the built-up road grime, fluids, tars and oils enough to be manually rinsed off prior to disassembly and repair.
A fairly well-defined reaction front can often be observed in thin sections; ahead of the front the concrete is normal, or near normal. Behind the reaction front, the composition and the microstructure of concrete are modified. These changes may vary in type or severity but commonly include: Extensive cracking; Expansion
Concrete sealers are applied to concrete to protect it from surface damage, corrosion, and staining. They either block the pores in the concrete to reduce absorption of water and salts or form an impermeable layer which prevents such materials from passing.