Search results
Results from the WOW.Com Content Network
Nominal Pipe Size (NPS) is a North American set of standard sizes for pipes used for high or low pressures and temperatures. [1] " Nominal" refers to pipe in non-specific terms and identifies the diameter of the hole with a non-dimensional number (for example – 2-inch nominal steel pipe" consists of many varieties of steel pipe with the only criterion being a 2.375-inch (60.3 mm) outside ...
Common sizes are 15 mm and 22 mm. [7] Other sizes include 18 mm, 28 mm, 35 mm, 42 mm, 54 mm, 66.7 mm, 76.1 mm, and 108 mm outside diameters. Tubing in 8 mm and 10 mm outside diameters is called a "micro bore" and is easier to install, although there is a slightly increased risk of blockage from scale or debris.
Common rifle cartridges, from the largest .50 BMG to the smallest .22 Long Rifle with a $1 United States dollar bill in the background as a reference point.. This is a table of selected pistol/submachine gun and rifle/machine gun cartridges by common name.
where is the density of the fluid, is the average velocity in the pipe, is the friction factor from the Moody chart, is the length of the pipe and is the pipe diameter. The chart plots Darcy–Weisbach friction factor against Reynolds number Re for a variety of relative roughnesses, the ratio of the mean height of roughness of the pipe to the ...
The .50 GI (12.7×23mmRB) pistol cartridge was developed by Alex Zimmermann of Guncrafter Industries. The .50 GI was introduced at the 2004 SHOT Show alongside the Guncrafter Industries Model No. 1, a variation of the M1911. The round has a rebated rim that is the same diameter as that of the .45 ACP. [1] [2]
The smaller .500" diameter was further popularized by the development of the .500 S&W Magnum in 2003. [2] There are semi-automatic, revolver, and single-shot.50 caliber handgun designs. Handguns of this caliber tend to be larger and heavier than most others of their type with the exception of the Linebaugh line of revolvers.
The history of copper pipe is similar. In the 1930s, the pipe was designated by its internal diameter and a 1 ⁄ 16-inch (1.6 mm) wall thickness. Consequently, a 1-inch (25 mm) copper pipe had a 1 + 1 ⁄ 8-inch (28.58 mm) outside diameter. The outside diameter was the important dimension for mating with fittings.
Alternatively, reducer may refer to any fitting which causes a change in pipe diameter. [15] This change may be intended to meet hydraulic flow requirements of the system or adapt to existing piping of a different size. The reduction length is usually equal to the average of the larger and smaller pipe diameters.