enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Internal ballistics - Wikipedia

    en.wikipedia.org/wiki/Internal_ballistics

    Barrel time - the time from when the projectile starts to move until it exits the barrel. Diagram of internal ballistic phases. The burning firearm propellant produces energy in the form of hot gases that raise the chamber pressure which applies a force on the base of the projectile, causing it to accelerate. The chamber pressure depends on the ...

  3. Free recoil - Wikipedia

    en.wikipedia.org/wiki/Free_recoil

    Free recoil / Frecoil is a vernacular term or jargon for recoil energy of a firearm not supported from behind. Free recoil denotes the translational kinetic energy (E t) imparted to the shooter of a small arm when discharged and is expressed in joules (J), or foot-pound force (ft·lb f) for non-SI units of measure.

  4. Muzzle energy - Wikipedia

    en.wikipedia.org/wiki/Muzzle_energy

    Muzzle energy is dependent upon the factors previously listed, and velocity is highly variable depending upon the length of the barrel a projectile is fired from. [2] Also the muzzle energy is only an upper limit for how much energy is transmitted to the target, and the effects of a ballistic trauma depend on several other factors as well ...

  5. Ballistic coefficient - Wikipedia

    en.wikipedia.org/wiki/Ballistic_coefficient

    Siacci found that within a low-velocity restricted zone, projectiles of similar shape, and velocity in the same air density behave similarly; or . Siacci used the variable for ballistic coefficient. Meaning, air density is the generally the same for flat-fire trajectories, thus sectional density is equal to the ballistic coefficient and air ...

  6. Small arms ammunition pressure testing - Wikipedia

    en.wikipedia.org/wiki/Small_arms_ammunition...

    The test cartridge must be inserted into the chamber in such a way that the hole in the test cartridge case lines up with a gas port hole that channels the gas pressure from the cartridge case to the face of the sensor. The measurement accuracy of the pressure measurements with 21st century high-pressure sensors is expected to be ≤ 2%. [7]

  7. Ballistic table - Wikipedia

    en.wikipedia.org/wiki/Ballistic_table

    Example of a ballistic table for a given 7.62×51mm NATO load. Bullet drop and wind drift are shown both in mrad and MOA.. A ballistic table or ballistic chart, also known as the data of previous engagements (DOPE) chart, is a reference data chart used in long-range shooting to predict the trajectory of a projectile and compensate for physical effects of gravity and wind drift, in order to ...

  8. NATO EPVAT testing - Wikipedia

    en.wikipedia.org/wiki/NATO_EPVAT_testing

    Each weapon and component considered vulnerable to the effects of a rapid change in pressure, for example barrels, breech blocks and bolts, will be tested by firing one dry round at a corrected minimum of 25% over-pressure and one oiled round at a corrected minimum of 25% over-pressure. 25% over-pressure means 25% in excess of the Service ...

  9. Transitional ballistics - Wikipedia

    en.wikipedia.org/wiki/Transitional_ballistics

    The initial velocity (Vo) and real muzzle velocity (Vr) difference. During the first part of the intermediate ballistics period the real velocity of the projectile increases. It is caused by the propellant gases exiting the muzzle. For that reason the real maximum projectile velocity (Vmax) is higher than the real muzzle velocity (Vr).