Search results
Results from the WOW.Com Content Network
An oscillating force is applied to a polymer sample and the sample’s response is recorded. DMA documents the lag between force applied and deformation recovery in the sample. Viscoelastic samples exhibit a sinusoidal modulus called the dynamic modulus. Both energy recovered and lost are considered during each deformation and described ...
The yield function is often expressed as an equation consisting of some invariant of stress and a model for the yield stress (or plastic flow stress). An example is von Mises or plasticity. In those situations the plastic strain rate is calculated in the same manner as in rate-independent plasticity.
The definition of strain rate was first introduced in 1867 by American metallurgist Jade LeCocq, who defined it as "the rate at which strain occurs. It is the time rate of change of strain." In physics the strain rate is generally defined as the derivative of the strain with respect to time. Its precise definition depends on how strain is measured.
The Lankford coefficient (also called Lankford value, R-value, or plastic strain ratio) [1] is a measure of the plastic anisotropy of a rolled sheet metal. This scalar quantity is used extensively as an indicator of the formability of recrystallized low-carbon steel sheets.
Low cycle fatigue (LCF) has two fundamental characteristics: plastic deformation in each cycle; and low cycle phenomenon, in which the materials have finite endurance for this type of load. The term cycle refers to repeated applications of stress that lead to eventual fatigue and failure; low-cycle pertains to a long period between applications.
In continuum mechanics, elastic shakedown behavior is one in which plastic deformation takes place during running in, while due to residual stresses or strain hardening the steady state is perfectly elastic. Plastic shakedown behavior is one in which the steady state is a closed elastic-plastic loop, with no net accumulation of plastic deformation.
Strain crystallization occurs when the chains of molecules in a material become ordered during deformation activities in some polymers and elastomers. [2] The three primary factors that affect strain crystallization are the molecular structure of the polymer or elastomer, the temperature, and the deformation being applied to the material. [3]
The cyclic changes described above produce serrations in the plastic region of the stress strain diagram of a tensile test that is undergoing the Portevin-Le Chatelier effect. The variation in stress also causes non-homogeneous deformation to occur throughout the sample which can be visible to the naked eye through observation of a rough finish.