Search results
Results from the WOW.Com Content Network
USB 3.0 SuperSpeed and USB 2.0 High-Speed versions defined USB 3.0 SuperSpeed – host controller (xHCI) hardware support, no software overhead for out-of-order commands; USB 2.0 High-speed – enables command queuing in USB 2.0 drives; Streams were added to the USB 3.0 SuperSpeed protocol for supporting UAS out-of-order completions
At first, Adaptec focused on devices with Parallel SCSI interfaces. Popular host bus adapters included the 154x/15xx ISA family, the 2940 PCI family, and the 29160/-320 family. Their cross-platform ASPI was an early API for accessing and integrating non- disk devices like tape drives , scanners and optical disks .
Early SCSI interfaces commonly used a 50-pin micro ribbon connector. This connector is similar to the 36-pin connector used by Centronics for the parallel interface on their printers, thus the connector became popularly known as "Centronics SCSI" or "CN-50". It is also referred to as a "SCSI-1 connector"; since many connectors have been used ...
In Fibre Channel, the port identifier is a WWPN and the device name is a WWNN. In SAS, both SCSI port identifiers and SCSI device names take the form of a SAS address, which is a 64 bit value, normally in the NAA IEEE Registered format. People sometimes refer to a SCSI port identifier as the SAS address of a device, out of confusion. People ...
The physical phenomena on which the device relies (such as spinning platters in a hard drive) will also impose limits; for instance, no spinning platter shipping in 2009 saturates SATA revision 2.0 (3 Gbit/s), so moving from this 3 Gbit/s interface to USB 3.0 at 4.8 Gbit/s for one spinning drive will result in no increase in realized transfer rate.
Adaptec also developed generic SCSI disk and CD-ROM drivers for DOS (ASPICD.SYS and ASPIDISK.SYS). [3]: 60–61 At least a couple of other programming interfaces for SCSI device drivers competed with ASPI in the early 1990s, including CAM (Common Access Method), developed by Apple; and Layered Device Driver Architecture, developed by Microsoft.
USB 3.0 port provided by an ExpressCard-to-USB 3.0 adapter may be connected to a separately-powered USB 3.0 hub, with external devices connected to that USB 3.0 hub. On the motherboards of desktop PCs which have PCI Express (PCIe) slots (or the older PCI standard), USB 3.0 support can be added as a PCI Express expansion card .
On a parallel SCSI bus, a device (e.g. host adapter, disk drive) is identified by a "SCSI ID", which is a number in the range 0–7 on a narrow bus and in the range 0–15 on a wide bus. On earlier models a physical jumper or switch controls the SCSI ID of the initiator ( host adapter ).