Search results
Results from the WOW.Com Content Network
Produced from 1958 through 1960, it was only used in Mercury vehicles. It used a 4.30 in × 3.30 in (109.2 mm × 83.8 mm) bore and stroke. Output began at 312 or 330 hp (233 or 246 kW), both with a four-barrel carburetor. The 322 hp (240 kW) was the only output for 1959, and power dropped to 280 hp (209 kW) for the final year.
The Mercury Y-Block was 256 cu in (4,194 cc) and produced 161 bhp (120 kW), [3] again a similar displacement to the 255 cu in (4.2 L) Mercury Flathead V8 it replaced, but with 29% more power than the older engine's 125 bhp (93 kW). [4] The original Lincoln V8 was also known as a Y-Block. Lincoln introduced their engine in 1952, but it was a ...
Because of interchangeability, the Mercury crank made a popular upgrade in the 239 among hot rodders. In fact, in the 1950s, the flathead block was often fitted with crankshafts of up to 4.125 in (104.8 mm) stroke. [21] In addition, rodders in the 1950s routinely bored them out by 0.1875 in (4.76 mm) (to 3.375 in [85.7 mm]). [21]
Four-stroke cycle used in gasoline/petrol engines: intake (1), compression (2), power (3), and exhaust (4). The right blue side is the intake port and the left brown side is the exhaust port. The cylinder wall is a thin sleeve surrounding the piston head which creates a space for the combustion of fuel and the genesis of mechanical energy.
3-valve 5.4 L and 6.8 L engines built before 10/9/07 and 3-valve 4.6 Ls built before 11/30/07 found in many 2004–2008 Ford, Lincoln, and Mercury vehicles have an issue with difficult-to-remove spark plugs, which can cause part of the spark plug to become seized in the cylinder head.
The Mercury Monterey is a series of full-size cars that were manufactured and marketed by the Mercury division of Ford from 1950 to 1974. Deriving its name from Monterey Bay, the initial Mercury Monterey served as the top-of-the-line two-door sedan model for 1950 and 1951 to compete with the hardtop models of Oldsmobile and Buick.
It is a stroked 332 with 3.5 in (88.90 mm) stroke and a 4 in (101.60 mm) bore, and was rated from 208 bhp (155.1 kW) with a 2-barrel carburetor to over 300 bhp (223.7 kW) on the 4-barrel models. When these engines were introduced, they were called Interceptor V-8 on the base models and Interceptor Special V-8 on the 4-barrel models. [ 4 ]
Oil slosh occurs in dry-sump systems too, but it is much easier to design a remote reservoir to tolerate high amounts of slosh, by being tall and narrow, and having large baffles. Increased oil capacity by using a large external reservoir, which would be impractical in a wet-sump system. Improvements to vehicle handling and stability.