Search results
Results from the WOW.Com Content Network
A grid-tie inverter converts direct current (DC) into an alternating current (AC) suitable for injecting into an electrical power grid, at the same voltage and frequency of that power grid. Grid-tie inverters are used between local electrical power generators: solar panel , wind turbine , hydro-electric , and the grid.
A power inverter, inverter, or invertor is a power electronic device or circuitry that changes direct current (DC) to alternating current (AC). [1] The resulting AC frequency obtained depends on the particular device employed. Inverters do the opposite of rectifiers which were originally large electromechanical devices converting AC to DC. [2]
A soft-switching three-level inverter (S3L inverter) is a high-efficiency power electronic inverter intended, in particular, for use with three-phase drives, as a grid-tie inverter for photovoltaic installations or wind turbines and in power supplies. [1] The topology was developed in 2009 at HTWG Konstanz (Constance University of Applied ...
An inverter-based resource (IBR) is a source of electricity that is asynchronously connected to the electrical grid via an electronic power converter ("inverter"). The devices in this category, also known as converter interfaced generation ( CIG ), include the variable renewable energy generators (wind, solar) and battery storage power stations ...
This is a list of the power supply systems that are, or have been, used for railway electrification. Note that the voltages are nominal and vary depending on load and distance from the substation. As of 2023 many trams and trains use on-board solid-state electronics to convert these supplies to run three-phase AC traction motors.
In air conditioning, an inverter compressor is a compressor that is operated with an inverter. In the hermetic type, it can either be a scroll or reciprocating compressor . This type of compressor uses a drive to control the compressor motor speed to modulate cooling capacity.
HVDC converters can take several different forms. Early HVDC systems, built until the 1930s, were effectively rotary converters and used electromechanical conversion with motor-generator sets connected in series on the DC side and in parallel on the AC side. However, all HVDC systems built since the 1940s have used electronic (static) converters.
An HVDC thyristor valve tower 16.8 m tall in a hall at Baltic Cable AB in Sweden A battery charger is an example of a piece of power electronics. A PCs power supply is an example of a piece of power electronics, whether inside or outside of the cabinet.