Search results
Results from the WOW.Com Content Network
The glowing splint test is a test for an oxidising gas, such as oxygen. [4] In this test, a splint is lit, allowed to burn for a few seconds, then blown out by mouth or by shaking. Whilst the ember at the tip is still glowing hot, the splint is introduced to the gas sample that has been trapped in a vessel. [4]
[specify] [2] [3] A glowing splint can be used to show that the gas produced is oxygen. [9] The rate of foam formation measured in volume per time unit has a positive correlation with the peroxide concentration (v/V%), which means that more foam will be generated per unit time when a more concentrated peroxide solution is used. [10]
Chemiluminescence (also chemoluminescence) is the emission of light (luminescence) as the result of a chemical reaction, i.e. a chemical reaction results in a flash or glow of light. A standard example of chemiluminescence in the laboratory setting is the luminol test. Here, blood is indicated by luminescence upon contact with iron in hemoglobin.
Radioluminescent 1.8-curie (67 GBq) 6-by-0.2-inch (152.4 mm × 5.1 mm) tritium vials are tritium gas-filled, thin glass vials with inner surfaces coated with a phosphor. Tritium radioluminescence is the use of gaseous tritium , a radioactive isotope of hydrogen , to create visible light.
A flame test is relatively quick test for the presence of some elements in a sample. The technique is archaic and of questionable reliability, but once was a component of qualitative inorganic analysis .
The prepared gas is usually impure, contaminated with fine aerosol of the reagents and water vapor. The gases may need to be filtered, washed and dried before further use. Hydrogen can be washed from sulfane, arsine and oxygen with subsequent bubbling through solutions of lead acetate, silver nitrate, and alkaline pyrogallic acid. [4]
Similarly, a eudiometer uses water to release gas into the eudiometer tube, converting the gas into a visible, measurable amount. A correct measurement of the pressure when performing these experiments is crucial for the calculations involved in the PV = nRT equation, because the pressure could change the density of the gas.
A flicker light bulb, flicker flame light bulb or flicker glow lamp is a gas-discharge lamp which produces light by ionizing a gas, usually neon mixed with helium and a small amount of nitrogen gas, by an electric current passing through two flame shaped electrode screens coated with partially decomposed barium azide. The ionized gas moves ...