Search results
Results from the WOW.Com Content Network
This is a 2003 era programmer for the Microchip "PIC" family of microcontrollers. It connects by RS 232 cable to a PC compatible running development software. In 2003 this unit cost $300 Canadian (about $200 US at the time). Devices called "programmers" are traditionally used to get program code into the target PIC.
On-board USB, Ethernet, Wi-Fi, SD card slot. Support for the .NET Micro Framework. Development environment is MS Visual Studio and C#. Pin compatible with Arduino shields although drivers are required for some shields. [271] Vinculo [272] Vinculum II FTDI USB development board for the FTDI Vinculum II microcontroller.
This also allows downloads to be made with a simple serial connection which eliminates the need for a PIC programmer. [3] PICAXE is programmed using an RS-232 serial cable [ 4 ] or a USB cable [ 5 ] which connects a computer to the download circuit, which normally uses a 3.5 mm jack and two resistors .
The PICkit 1 was a rudimentary USB programmer for PIC microcontrollers, produced by Microchip Technology, the manufacturer of the PIC series of microcontrollers. It was introduced on March 31, 2003, priced at US$36. [1] The PICkit 1 was integrated into a demonstrator board, featuring eight LEDs, a switch, and a potentiometer. Its default ...
MPLAB X is the latest version of the MPLAB IDE built by Microchip Technology, and is based on the open-source NetBeans platform. MPLAB X supports editing, very buggy debugging and programming of Microchip 8-bit, 16-bit and 32-bit PIC microcontrollers.
The ELM327 is a programmed microcontroller produced for translating the on-board diagnostics (OBD) interface found in most modern cars. The ELM327 command protocol is one of the most popular PC-to-OBD interface standards and is also implemented by other vendors.
The STK600 allows in-system programming from the PC via USB, leaving the RS-232 port available for the target microcontroller. A 4 pin header on the STK600 labeled 'RS-232 spare' can connect any TTL level USART port on the chip to an onboard MAX232 chip to translate the signals to RS-232 levels. The RS-232 signals are connected to the RX, TX ...
Easy boards Full-featured development boards with onboard programmers. Users can plug different microcontrollers via DIP sockets or specialized PCB cards. EasyPIC v7 (for 8-bit PIC microcontrollers) click boards 1600+ add-on boards with a standardized connector and form factor. Each board carries a single sensor or transceiver from numerous ...