Search results
Results from the WOW.Com Content Network
A ball bearing. A bearing is a machine element that constrains relative motion to only the desired motion and reduces friction between moving parts.The design of the bearing may, for example, provide for free linear movement of the moving part or for free rotation around a fixed axis; or, it may prevent a motion by controlling the vectors of normal forces that bear on the moving parts.
A sealed deep groove ball bearing. In mechanical engineering, a rolling-element bearing, also known as a rolling bearing, [1] is a bearing which carries a load by placing rolling elements (such as balls, cylinders, or cones) between two concentric, grooved rings called races.
Although bearings had been developed since ancient times, the first modern recorded patent on ball bearings was awarded to Philip Vaughan, a Welsh inventor and ironmaster who created the first design for a ball bearing in Carmarthen in 1794. His was the first modern ball-bearing design, with the ball running along a groove in the axle assembly.
A bearing surface in mechanical engineering is the area of contact between two objects. It usually is used in reference to bolted joints and bearings, but can be applied to a wide variety of engineering applications. The choice of bearing surface depends on the application, load, speed, and operating conditions, and the design must be able to ...
A plain bearing, or more commonly sliding contact bearing and slide bearing ... Also includes an e-book library of classic texts on mechanical design and engineering.
Preload becomes very important for large mechanical and high performance system such as large Telescopes. [2] In the general sense, it refers to the internal application of stress to certain mechanical systems. By tensioning, preloading increases the natural frequency of a structure, avoiding resonance due to external disturbances.
In mechanical engineering, it is one part of a rotating joint where a shaft (the trunnion) is inserted into (and turns inside) a full or partial cylinder. Often used in opposing pairs, this joint allows tight tolerances and strength from a large surface contact area between the trunnion and the cylinder.
In the case of ball bearings, the bearing has inner and outer races and a set of balls. Each race is a ring with a groove where the balls rest. The groove is usually shaped so the ball is a slightly loose fit in the groove. Thus, in principle, the ball contacts each race at a single point.