Search results
Results from the WOW.Com Content Network
A lathe faceplate is a basic workholding accessory for a wood or metal turning lathe. It is a circular metal (usually cast iron) plate which fixes to the end of the lathe spindle. The workpiece is then clamped to the faceplate, typically using t-slot nuts in slots in the faceplate, or less commonly threaded holes in the faceplate itself.
It is numbered with a stylized flag symbol surrounding the number (or sometimes a delta symbol). A general note applies generally and is not called out with flags. 2. Find number: "FN" meaning "find number" refers to the ordinal number that gives an ID tag to one of the constituents in a parts list (list of materials, bill of materials).
A lathe dog is a mechanical device typically made of cast iron, steel or aluminum that transmits rotary motion from a faceplate to a workpiece mounted between centers in a lathe. [1] The tail of the dog is rotated by a slot in a driving faceplate, a stud mounted on a faceplate, or sometimes a side of a chuck jaw.
A backplate with threads may screw onto a threaded spindle nose (for lathe work) or onto an adapter plate with the same nose, to be mounted on the table of milling machines or surface grinding machines. This "threaded spindle nose" type of mounting was the typical method in the 19th century through 1930s.
Dead center (the conical piece) mounted in the spindle of a lathe and being used to support a workpiece being driven by a carrier setup. A lathe center, often shortened to center, is a tool that has been ground to a point to accurately position a workpiece on an axis. They usually have an included angle of 60°, but in heavy machining ...
Spindle nose on a lathe headstock. The small female taper is a Morse taper to take a lathe center or a tool such as a twist drill. The large male taper takes a lathe chuck, which is retained by the large nut. A machine taper is a system for securing cutting tools or toolholders in the spindle of a machine tool or power tool.
For example, an indexing plate might have three rows of holes with 24, 30, and 36 holes in each row. A pin on the hand crank engages these holes. Index plates with up to 400 holes are available. [2] Only one such plate can be mounted to the dividing head at a time. The plate is selected by the machinist based on exactly what angle he wishes to ...
Cutting speed may be defined as the rate at the workpiece surface, irrespective of the machining operation used. A cutting speed for mild steel of 100 ft/min is the same whether it is the speed of the cutter passing over the workpiece, such as in a turning operation, or the speed of the cutter moving past a workpiece, such as in a milling operation.