Search results
Results from the WOW.Com Content Network
An external wastegate requires a specially constructed turbo manifold with a dedicated runner going to the wastegate. The external wastegate may be part of the exhaust housing itself. External wastegates are commonly used for regulating boost levels more precisely than internal wastegates in high power applications, where high boost levels can ...
A 3-port solenoid-type boost controller A 4-port solenoid-type boost controller (used for a dual-port wastegate). The purpose of a boost controller is to reduce the boost pressure seen by the wastegate's reference port, in order to trick the wastegate into allowing higher boost pressures than it was designed for.
1973: The next mass-produced turbocharged car was the BMW 2002 Turbo, introduced at the 1973 Frankfurt motor show and featuring a 2.0 L (120 cu in) four-cylinder engine. [10] Due to excessive turbo lag, safety concerns and the 1973/1974 oil crisis, the 2002 Turbo was discontinued in 1974. [10]
A major part of the torque is due to friction, so the differences in friction can cause large variations of the preload with the same torque setting; [3] angle-controlled tightening (also known as turn-of-the-nut method) is a technique where the bolt joint is rotated to some angle that ensures the stress beyond the yield limit of the parts ...
A screamer pipe is a type of exhaust configuration fitted to some automotive turbocharged petrol engines with an external wastegate set-up, which vents the waste exhaust to the atmosphere through a separate un-muffled pipe, rather than back into the main exhaust track. This exhaust setup is known for its loud noise.
The anti-lag system (ALS) is a method of reducing turbo lag or effective compression used on turbocharged engines to minimize turbo lag on racing or performance cars. It works by retarding the ignition timing and adding extra fuel (and sometimes air) to balance an inherent loss in combustion efficiency with increased pressure at the charging side of the turbo.
This design has a lower flow rate compared to VNT types so a wastegate may be incorporated with this design. [5] VGTs may be controlled by a membrane vacuum actuator, electric servo, 3-phase electric actuation, hydraulic actuator, or pneumatic actuator using air brake pressure. Unlike fixed-geometry turbines, VGTs do not require a wastegate. [6]
In an internal combustion engine, a turbocharger (also known as a turbo or a turbosupercharger) is a forced induction device that is powered by the flow of exhaust gases. It uses this energy to compress the intake air, forcing more air into the engine in order to produce more power for a given displacement .