Ad
related to: rafter heel cut out board ideas for concrete walls constructionConcreteNetwork.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
A birds-mouth joint in a rafter, set upon a double top plate. Shown are the two cuts of the joint: the seat cut and the heel cut. In light frame construction, a birdsmouth joint or bird's beak cut is a woodworking joint that is generally used to connect a roof rafter to the top plate of a supporting wall. [1]
Crosswall construction is a building technique that uses prefabricated concrete modules with load-bearing walls that act to communicate the entire weight of the building to its foundation. [ 1 ] [ 2 ] [ 3 ]
The first rafter is fitted between the wall and the temporary central support and then further rafters are added, each resting on the last. The final rafter fits on top of the previous rafter and under the very first one. The rafters are then tied before the temporary support is removed.
A slurry wall is a civil engineering technique used to build reinforced concrete walls in areas of soft earth close to open water, or with a high groundwater table. [1] This technique is typically used to build diaphragm (water-blocking) walls surrounding tunnels and open cuts, and to lay foundations .
Eaves of a house in Northern Australia.The white underside would be referred to as a soffit. In this example the soffit is fixed to the slope of the rafters.The dark grey fascia boards form the outer edge and have a groove to receive the soffit lining sheets which cover the rafter tails.
The horizontal "fascia board" which caps the end of rafters outside a building may be used to hold the rain gutter. The finished surface below the fascia and rafters is called the soffit or eave. In classical architecture, the fascia is the plain, wide band (or bands) that make up the architrave section of the entablature, directly above the ...
Among its basic uses are marking common, hip, valley and hip, or valley jack rafters, laying out stair stringers, determining and marking angles, and making square cuts on boards. Common lines made using a speed square include perpendicular cut marks and Angles definition of an angle for roofs, stairways, and decks. The tool uses a 0° reference.
A knee wall is a short wall, typically under three feet (one metre) in height, used to support the rafters in timber roof construction. In his book A Visual Dictionary of Architecture , Francis D. K. Ching defines a knee wall as "a short wall supporting rafters at some intermediate position along their length."
Ad
related to: rafter heel cut out board ideas for concrete walls constructionConcreteNetwork.com has been visited by 10K+ users in the past month