Search results
Results from the WOW.Com Content Network
Eurocard is an IEEE standard format for printed circuit board (PCB) cards that can be plugged together into a standard chassis which, in turn, can be mounted in a 19-inch rack. The chassis consists of a series of slotted card guides on the top and bottom, into which the cards are slid so they stand on end, like books on a shelf.
The four mounting holes in a Mini-ITX board line up with four of the holes in ATX-specification motherboards, and the locations of the backplate and expansion slot are the same [2] (though one of the holes used was optional in earlier versions of the ATX spec). Mini-ITX boards can therefore often be used in cases designed for ATX, micro-ATX and ...
Requires a carrier board. COM Express Mini PICMG: 2005 55 × 84 mm (2.17 × 3.31 in) Used in embedded systems and single-board computers. Requires a carrier board. Adheres to pin-out Type 10 [3] COM-HPC Size A PICMG: 2020 95 × 120 mm (3.7 × 4.7 in) Used in embedded systems. Requires a carrier board. Typically used for COM-HPC Client Type modules.
ATX power supplies generally have the dimensions of 150 × 86 × 140 mm (5.9 × 3.4 × 5.5 in), [22]: 23–24 with the width and height being the same as the preceding LPX (Low Profile eXtension) form factor (which are often incorrectly referred to as "AT" power supplies due to their ubiquitous use in later AT and Baby AT systems, even though ...
Pico BTX motherboards measure 8 × 10.5 in (203 × 267 mm). This is smaller than many current "micro"-sized motherboards, hence the name " pico ". These motherboards share a common top half with the other sizes in the BTX line, but support only one or two expansion slots, designed for half-height or riser card applications.
The Serener PXFPIO (also labeled under VIA PX-DIO) is 109mm × 22mm in size and connects via a 120mm ribbon cable through a daughter card. This addon may require modification to the heatsink due to the size of the daughter card. It supplies access to: power & reset switches; 3.5mm audio in/out; S/PDIF-in; power & HDD activity LEDs; 4 USB 2.0 ...
These motherboards have similar mounting hole positions and the same eight card slot locations as those with the AT form factor, but are 8.5 in (216 mm) wide and marginally shorter than full-size AT boards, with a maximum length of 13 in (330 mm). However, Baby AT boards were mostly shorter than this, typically 9 to 10 in (229 to 254 mm). [3]
Nano-ITX is a computer motherboard form factor first proposed by VIA Technologies at CeBIT in March 2003, [1] [2] and implemented in late 2005. Nano-ITX boards measure 12 × 12 cm (4.7 × 4.7 in), and are fully integrated, very low power consumption motherboards with many uses, but targeted at smart digital entertainment devices such as DVRs, set-top boxes, media centers, car PCs, and thin ...