Search results
Results from the WOW.Com Content Network
British Standard Pipe (BSP) is a set of technical standards for screw threads that has been adopted internationally for interconnecting and sealing pipes and fittings by mating an external thread with an internal (female) thread.
For both of these rules of thumb (85%/90% and major minus pitch), the tap drill size yielded is not necessarily the only possible one, but it is a good one for general use. The 85% and 90% rules works best in the range of 1 ⁄ 4 –1 in (6.4–25.4 mm), the sizes most important on many shop floors. Some sizes outside that range have different ...
No. 7/0, the largest size, is 0.50 in. (500 thou or 12.7 mm) dia., No. 1 is 0.30 in. (300 thou), and the smallest, No. 50, is 0.001 in. (1 thou or 25.4 µm). The system as a whole approximates an exponential curve, plotting diameter against gauge-number (each size is a approximately a constant multiple of the previous size). The weight per unit ...
All S275JOH steel material and S275JOH pipes should conform to EN10219 standards. [4] The normal yield strength grades available are 195, 235, 275, 355, 420, and 460, although some grades are more commonly used than others e.g. in the UK, almost all structural steel is grades S275 and S355.
Sizes under 100 lb/yd (49.6 kg/m) rail are usually for lighter duty freight, low use trackage, or light rail. Track using 100 to 120 lb/yd (49.6 to 59.5 kg/m) rail is for lower speed freight branch lines or rapid transit ; for example, most of the New York City Subway system track is constructed with 100 lb/yd (49.6 kg/m) rail.
Number drill bit gauge sizes range from size 80 (the smallest) to size 1 (the largest) followed by letter gauge size A (the smallest) to size Z (the largest). Although the ASME B94.11M twist drill standard, for example, lists sizes as small as size 97, sizes smaller than 80 are rarely encountered in practice.
EN 10027-1 steel grade designation system. European standard steel grade names fall into two categories: [1] Steel specified by purpose of use and mechanical properties. Steel specified by chemical composition. The inclusion of a letter 'G' before the code indicates the steel is specified in the form of a casting.
Confusion can arise because each Whitworth hexagon was originally one size larger than that of the corresponding BSF fastener. This leads to instances where for example, a spanner marked 7 ⁄ 16 BSF is the same size as one marked 3 ⁄ 8 W. In both cases the spanner jaw width of 0.710 in, the width across the hexagon flat, is the same.