Search results
Results from the WOW.Com Content Network
A set of MAPP and oxygen cylinders is used for oxy-fuel welding and cutting.. MAPP gas was a trademarked name, belonging to The Linde Group, a division of the former global chemical giant Union Carbide, for a fuel gas based on a stabilized mixture of methylacetylene (propyne), propadiene and propane.
MAPP gas can be used at much higher pressures than acetylene, sometimes up to 40 or 50 psi in high-volume oxy-fuel cutting torches which can cut up to 12-inch-thick (300 mm) steel. Other welding gases that develop comparable temperatures need special procedures for safe shipping and handling.
Main page; Contents; Current events; Random article; About Wikipedia; Contact us; Donate
They are also used widely in heat flux sensors and pyrheliometers [5] [6] and gas burner safety controls. The output of a thermopile is usually in the range of tens or hundreds of millivolts. [7] As well as increasing the signal level, the device may be used to provide spatial temperature averaging. [8]
The resistance of the titania is a function of the oxygen partial pressure and the temperature. Therefore, some sensors are used with a gas-temperature sensor to compensate for the resistance change due to temperature. The resistance value at any temperature is about 1/1000 the change in oxygen concentration.
Methylacetylene-propadiene (MPS) gas is a type of fuel gas used in oxy-fuel welding and cutting torches, comprising a mixture of several gases. MPS gases [ edit ]
If the gas is heated so that the temperature of the gas goes up to T 2 while the piston is allowed to rise to V 2 as in Figure 1, then the pressure is kept the same in this process due to the free floating piston being allowed to rise making the process an isobaric process or constant pressure process. This Process Path is a straight horizontal ...
Oxygen and MAPP gas cylinders with two-stage pressure regulators Schematic diagram of pressure reducing regulator (A) and back-pressure regulator (B). The upper diagrams show the normal state for the valves, which is normally open for pressure reducers and normally closed for back-pressure valves.