enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. AN thread - Wikipedia

    en.wikipedia.org/wiki/AN_thread

    For example, AN6 bolt has a 3 ⁄ 8-24 thread [3] whereas an -6 AN fitting has a 9 ⁄ 16-18 thread. [ 4 ] Originally parts were made compliant to the specification MIL-F-5509, but they are now controlled under SAE AS (Aerospace Standards) specifications AS4841 through AS4843 and AS4875.

  3. List of drill and tap sizes - Wikipedia

    en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

    Schematic of a machine tap. Below is a comprehensive drill and tap size chart for all drills and taps, imperial and metric, up to 36.5 millimetres (1.44 in) in diameter.. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.

  4. National pipe thread - Wikipedia

    en.wikipedia.org/wiki/National_pipe_thread

    The taper rate for all NPT threads is 1 inch of diameter in 16 inches of length (34 inch per foot or 62.5 millimeters per meter) measured by the change of diameter (of the pipe thread) over distance of thread.

  5. Unified Thread Standard - Wikipedia

    en.wikipedia.org/wiki/Unified_Thread_Standard

    The standard designation for a UTS thread is a number indicating the nominal (major) diameter of the thread, followed by the pitch measured in threads per inch.For diameters smaller than ⁠ 1 / 4 ⁠ inch, the diameter is indicated by an integer number defined in the standard; for all other diameters, the inch figure is given.

  6. AOL Mail

    mail.aol.com

    Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

  7. British Standard Pipe - Wikipedia

    en.wikipedia.org/wiki/British_Standard_Pipe

    In the modern standard metric version, it is simply a size number, where listed diameter size is the major outer diameter of the external thread. For a taper thread, it is the diameter at the "gauge length" (plus/minus one thread pitch) from the small end of the thread.

  8. Drill bit sizes - Wikipedia

    en.wikipedia.org/wiki/Drill_bit_sizes

    For Morse taper-shank drill bits, the standard continues in 1/64 inch increments up to 1¾ inch, then 1/32 inch increments up to 2¼ inch, 1/16 inch increments up to 3 inches, 1/8 inch increments up to 3¼ inches, and a single 1/4 inch increment to 3½ inches. One aspect of this method of sizing is that the size increment between drill bits ...

  9. Ring size - Wikipedia

    en.wikipedia.org/wiki/Ring_size

    In the United States, Canada, and Mexico, ring sizes are specified using a numerical scale with 14 steps, where whole sizes differ by 0.032 inches (0.81 mm) of internal diameter, equivalent to 0.1005 inches (2.55 mm) of internal circumference.