enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. ANSI/TIA-568 - Wikipedia

   en.wikipedia.org/wiki/ANSI/TIA-568

   A cable terminated according to T568A on one end and T568B on the other is a crossover cable when used with the earlier twisted-pair Ethernet standards that use only two of the pairs because the pairs used happen to be pairs 2 and 3, the same pairs on which T568A and T568B differ. Crossover cables are occasionally needed for 10BASE-T and ...

3. Ethernet over twisted pair - Wikipedia

   en.wikipedia.org/wiki/Ethernet_over_twisted_pair

   Most Ethernet cables are wired straight-through (pin 1 to pin 1, pin 2 to pin 2, and so on). In some instances, the crossover form (receive to transmit and transmit to receive) may still be required. Cables for Ethernet may be wired to either the T568A or T568B termination standards at both ends of the cable. Since these standards differ only ...

4. Modular connector - Wikipedia

   en.wikipedia.org/wiki/Modular_connector

   The cable between the computer and the keyboard is a coiled cord with an appearance very similar to a telephone handset cable. [11] The connector on the Amiga 1000 uses crossover wiring, similar to a telephone handset. The connector wiring on the Apple computers, however, requires a polarized straight-through pinout.

5. Ethernet - Wikipedia

   en.wikipedia.org/wiki/Ethernet

   An Ethernet port on a laptop computer connected to a twisted pair cable with an 8P8C modular connector Symbol used by Apple and Google on some devices to denote an Ethernet connection Ethernet ( / ˈ iː θ ər n ɛ t / EE -thər-net ) is a family of wired computer networking technologies commonly used in local area networks (LAN), metropolitan ...

6. Category 5 cable - Wikipedia

   en.wikipedia.org/wiki/Category_5_cable

   The cable standard prescribes performance parameters for frequencies up to 100 MHz and is suitable for 10BASE-T, 100BASE-TX (Fast Ethernet), 1000BASE-T (Gigabit Ethernet), and 2.5GBASE-T. 10BASE-T and 100BASE-TX Ethernet connections require two wire pairs. 1000BASE-T and faster Ethernet connections require four wire pairs.

7. Ethernet crossover cable - Wikipedia

   en.wikipedia.org/wiki/Ethernet_crossover_cable

   A standard straight-through cable is used for this purpose where each pin of the connector on one end is connected to the corresponding pin on the other connector. One terminal may be connected directly to another without the use of a switch or hub, but in that case, the crossover must be done in the cabling.