Search results
Results from the WOW.Com Content Network
Sv. ≡ 1 J/kg [44] = 1 Sv = 1 J/kg = 1 m 2 ⋅s 2. Although the definitions for sievert (Sv) and gray (Gy) would seem to indicate that they measure the same quantities, this is not the case. The effect of receiving a certain dose of radiation (given as Gy) is variable and depends on many factors, thus a new unit was needed to denote the ...
Therefore, a pressure altitude of 32,000 ft (9,800 m) is referred to as "flight level 320". In metre altitudes the format is Flight Level xx000 metres. Flight levels are usually designated in writing as FLxxx, where xxx is a two- or three-digit number indicating the pressure altitude in units of 100 feet (30 m). In radio communications, FL290 ...
Conversion of units is the conversion of the unit of measurement in which a quantity is expressed, typically through a multiplicative conversion factor that changes the unit without changing the quantity. This is also often loosely taken to include replacement of a quantity with a corresponding quantity that describes the same physical property ...
0.3048 m. 30.48 cm. 304.8 mm. The foot (standard symbol: ft) [1][2] is a unit of length in the British imperial and United States customary systems of measurement. The prime symbol, ′, is commonly used to represent the foot. [3] In both customary and imperial units, one foot comprises 12 inches, and one yard comprises three feet.
The basic unit of length in the imperial and U.S. customary systems is the yard, defined as exactly 0.9144 m by international treaty in 1959. [2] [5] Common imperial units and U.S. customary units of length include: [6] thou or mil (1 ⁄ 1000 of an inch) inch (25.4 mm) foot (12 inches, 0.3048 m) yard (3 feet, 0.9144 m)
Template. : Flight level. FL000 (0 ft; 0 m) Template documentation [view] [edit] [history] [purge] The template takes a three-digit Flight level number and converts it into feet and meters.
Length. For measuring length, the U.S. customary system uses the inch, foot, yard, and mile, which are the only four customary length measurements in everyday use. From 1893, the foot was legally defined as exactly 1200⁄3937 m (approximately 0.304 8006 m). [13] Since July 1, 1959, the units of length have been defined on the basis of 1 yd = 0 ...
However, it retained the Anglo-Saxon rod of 15 x 11 ⁄ 10 feet (5.03 metres) and the acre of 4 × 40 square rods. Thus, the rod went from 5 old yards to 5 + 1 ⁄ 2 new yards, or 15 old feet to 16 + 1 ⁄ 2 new feet. The furlong went from 600 old feet (200 old yards) to 660 new feet (220 new yards).