Ads
related to: power anchors for pontoon boats on youtube videos download
Search results
Results from the WOW.Com Content Network
A pontoon bridge (or ponton bridge), also known as a floating bridge, uses floats or shallow-draft boats to support a continuous deck for pedestrian and vehicle travel. The buoyancy of the supports limits the maximum load that they can carry. Most pontoon bridges are temporary and used in wartime and civil emergencies.
The reaction ferry uses the power of the river to tack across the current; the powered cable ferry uses engines or electric motors (e.g., the Canby Ferry in the U.S. State of Oregon) to wind itself across; or is hand-operated, such as the Stratford-upon-Avon chain ferry in the UK and the Saugatuck Chain Ferry in Saugatuck, Michigan, United States.
A pleasure boat with two lengthwise pontoons. A pontoon boat is a flattish boat that relies on floats to remain buoyant. These pontoons (also called tubes) contain much reserve buoyancy and allow designers to create large deck plans fitted with a variety of accommodations including expansive lounge areas, stand-up bars, and sun pads.
A conical sea anchor with tripline (from an illustration in The Sailors Handbook by Halsey C. Herreshoff). An early wooden drogue. A sea anchor (also known as a parachute anchor, drift anchor, drift sock, para-anchor or boat brake) is a device that is streamed from a boat in heavy weather. Its purpose is to stabilize the vessel and to limit ...
The anchor must be adequate to resist the maximum tensile load of the guy wires; both the dead load of the tension of the wire and the maximum possible live load due to wind. Since the guy wire exerts its force at an angle, the anchor has both vertical and lateral (horizontal) forces on it.
Holding ground is the area of sea floor that holds an anchor, and thus the attached ship or boat. [4] Different types of anchor are designed to hold in different types of holding ground. [5] Some bottom materials hold better than others; for instance, hard sand holds well, shell holds poorly. [6] Holding ground may be fouled with obstacles. [6]
As ships and their anchors grew in size, the anchor cable or chain would be too big to go around the capstan. Also, a wet cable or chain would be difficult to manage. A messenger would then be used as an intermediate device. This was a continuous loop of cable or chain which would go around the capstan.
For a small boat (e.g. 22' / 6.7 m sailing yacht), this might consist of a heavy weight on the seabed, a 12 mm or 14 mm rising chain attached to the "anchor", and a bridle made from 20 mm nylon rope, steel cable, or a 16 mm combination steel wire material. The heavy weight (anchor) should be a dense material.
Ads
related to: power anchors for pontoon boats on youtube videos download