Search results
Results from the WOW.Com Content Network
Now the results of the test are captured in the target flip-flops. Re-assert scan mode, and see if the combinatorial test passed. In a chip that does not have a full scan design -- i.e., the chip has sequential circuits, such as memory elements that are not part of the scan chain, sequential pattern generation is required. Test pattern ...
The output of a flip-flop is constant until a pulse is applied to its "clock" input, upon which the input of the flip-flop is latched into its output. In a synchronous logic circuit, an electronic oscillator called the clock generates a string (sequence) of pulses, the "clock signal".
An X value does not exist in hardware. In simulation, an X value can result from two or more sources driving a signal simultaneously, or the stable output of a flip-flop not having been reached. In synthesized hardware, however, the actual value of such a signal will be either 0 or 1, but will not be determinable from the circuit's inputs. [20]
In a synchronous circuit, two registers, or flip-flops, are said to be "sequentially adjacent" if a logic path connects them. Given two sequentially adjacent registers R i and R j with clock arrival times at the source and destination register clock pins equal to T Ci and T Cj respectively, clock skew can be defined as: T skew i, j = T Ci − T Cj.
An alternative solution to clock gating is to use Clock Enable (CE) logic on synchronous data path employing the input multiplexer, e.g., for D type flip-flops: using C / Verilog language notation: Dff= CE? D: Q; where: Dff is D-input of D-type flip-flop, D is module information input (without CE input), Q is D-type flip-flop output.
Setting J = K = 0 maintains the current state. To synthesize a D flip-flop, simply set K equal to the complement of J (input J will act as input D). Similarly, to synthesize a T flip-flop, set K equal to J. The JK flip-flop is therefore a universal flip-flop, because it can be configured to work as an SR flip-flop, a D flip-flop, or a T flip-flop.
If the output of the flip-flop is low, and a high clock pulse is applied with the input being a low pulse, then there is no need for a state transition. The extra computation to sample the inputs cause an increase in setup time of the flip-flop; this is a disadvantage of this technique. [3]
Here, the contamination delay is the amount of time needed for a change in the flip-flop clock input to result in the initial change at the flip-flop output (Q). If there is insufficient delay from the output of the first flip-flop to the input of the second, the input may change before the hold time has passed. Because the second flip-flop is ...