enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Flange nut - Wikipedia

   en.wikipedia.org/wiki/Flange_nut

   Serrated flange nuts. A flange nut is a nut that has a wide flange at one end that acts as an integrated washer.This serves to distribute the pressure of the nut over the part being secured, reducing the chance of damage to the part and making it less likely to loosen as a result of an uneven fastening surface.

3. Locknut - Wikipedia

   en.wikipedia.org/wiki/Locknut

   Keps nut (K-nut or washer nut) with a free-spinning washer. In the locknut form, this is a star-type lock washer. Plate nut; Polymer insert nut ; Security locknut All steel reusable nut for high vibration and harsh environments. Serrated face nut; Serrated flange nut; Speed nut (sheet metal nut or Tinnerman nut) Split beam nut (BINX nut [5])

4. Nut (hardware) - Wikipedia

   en.wikipedia.org/wiki/Nut_(hardware)

   Flange nut: Collar nut Has a wide flange at one end that acts as an integrated washer HARDLOCK Nut [3] Eccentric Double Nut A self-lock nut. Improvement of the double nut that uses a wedge principal, eliminating space between threads. Insert nut: Threaded socket A threaded socket for a wooden workpiece, similar to a wall anchor. Knurled nut ...

5. Bolt (fastener) - Wikipedia

   en.wikipedia.org/wiki/Bolt_(fastener)

   Bolts use a wide variety of head designs, as do screws. These are designed to engage with the tool used to tighten them. Some bolt heads instead lock the bolt in place, so that it does not move and a tool is only needed for the nut end. Common bolt heads include hex, slotted hex washer, and socket cap.

6. Washer (hardware) - Wikipedia

   en.wikipedia.org/wiki/Washer_(hardware)

   Assorted washers: flat, split, star and insulating. A washer is a thin plate (typically disk-shaped, but sometimes square) with a hole (typically in the middle) that is normally used to distribute the load of a threaded fastener, such as a bolt or nut.

7. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   They may either have a Phillips flat head or a slotted hex washer head. Nominal (thread) sizes range from 0.1875 to 0.375 in (4.763 to 9.525 mm) and lengths from 1.25 to 5 in (32 to 127 mm). Typically an installer uses a hammer drill to make a pilot hole for each concrete screw and a powered impact driver to drive the screw. The drill hole ...