Ads
related to: 6 disc shuffleboard sizes guide template 1 7 5 metric taper
Search results
Results from the WOW.Com Content Network
The Back-7 Line crosses the entire court. A center-line runs from the middle of the Back-7-line up the middle of the court for 6 feet (1.8 m). The two 7 score zones are located on each side of the Center-Line, for a length of 3 feet, bounded at the top by the Back-8 line, running side to side across and within the scoring triangle;
A shuffleboard player taking a shot. Table shuffleboard (also known as American shuffleboard, indoor shuffleboard, slingers, shufflepuck, and quoits, sandy table) is a game in which players push metal-and-plastic weighted pucks (also called weights or quoits) down a long and smooth wooden table into a scoring area at the opposite end of the table.
The rate of taper is 1:20 on diameter, in other words 0.600" on diameter per foot, .050" on diameter per inch. Tapers range from a Number 2 to a Number 20. The diameter of the big end in inches is always the taper size divided by 8, the small end is always the taper size divided by 10 and the length is the taper size divided by 2.
Board dimensions vary with a playing surface typically of polished wood or laminate approximately 26 inches (660 mm) in diameter. The arrangement is 3 concentric rings worth 5, 10, and 15 points as you move in from the outside. There is a shallow 20-point hole at the centre. [1] The inner 15-point ring is guarded with 8 small bumpers or posts.
Mass (kg): A 1-euro coin weighs 7.5 g; [27] a Sacagawea US 1-dollar coin weighs 8.1 g; [28] a UK 50-pence coin weighs 8.0 g. [29] Time (s): The use of minutes and hours instead of kilo and mega seconds: A second is 1 / 60 of a minute, which is 1 / 60 of an hour, which is 1 / 24 of a day, so a second is 1 / 86 400 ...
The taper is the change in the size of the diameter as you travel down the axis of the taper. So, take 1/2 the change size (1.75") and divide that by 12", arctan of the result is 1/2 the included angle. So 16.5942899... is correct. —Preceding unsigned comment added by SamELLI (talk • contribs) 17:45, 29 April 2008 (UTC) D'oh!
1 L; 1.5 L; 2 L; 3 L; 5 L; In the United States, the alcohol industry switched to metric bottle sizes on October 1, 1976, abandoning the existing 38 sizes of bottles and instead adopting the following 6 sizes: [2] 50 mL (miniature) 200 mL (replaced the half-pint) (≈237 mL is a U.S. half-pint) 500 mL (replaced the pint) (≈473 mL is a U.S. pint)
A taper pin is a fastener used in mechanical engineering. They are steel rods with one end having a slightly larger diameter than the other. Metric taper pins have a taper of 1:50. [1] A 1:50 taper means that one end of a 50 mm long bar will be 1 mm smaller in diameter than the other end.
Ads
related to: 6 disc shuffleboard sizes guide template 1 7 5 metric taper