Ads
related to: 1 4 to hex adapter connectorszoro.com has been visited by 1M+ users in the past month
Overall Customer Satisfaction 9.3 out of 10 - Bizrate.com
walmart.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
The interface dimensions for SMA connectors are listed in MIL-STD-348. [5] The SMA connector employs a 1 ⁄ 4 inch diameter, 36-thread-per-inch threaded barrel. The male is equipped with a hex nut measuring 5 ⁄ 16 inch (0.3125 inch / 7.9 mm) across opposite flats, thus taking the same wrench as a #6 SAE hex nut.
The 4.3-10 connector (sometimes referred to as 4.3/10) is a 50 Ω multi-purpose RF connector used to connect coaxial cables with other cables or RF devices, such as transmitters or antennas. The IEC standard 61169-54 specifies an inner diameter of the outer conductor is 10 mm and the outer diameter of the inner conductor is 4.3 mm.
A double DIN 1.6/5.6 bulkhead jack connector, crimp type, for 75 Ω coaxial cable A Type N connector (male), right-angled solder-type for semi-rigid coaxial cable with a diameter of 0.141-inch. 4.1-9.5 connector, standardized as DIN 47231 (in 1974) and IEC 60169-11 (in 1977) 4.3-10 connector, formerly known as DIN 4.3/10, now standardized as ...
Flare connection: 1) Screw thread; 2) O-ring; 3) Body; 4) Nut; 5) Seal interface; 6) Support ring (sleeve), and 7) Flared tubing. Flared connectors should not be confused with compression connectors, which are generally not interchangeable. Lacking a compression ring, they use a tapered conical shaped connection instead. A specialized flaring ...
Crown hex nut, blind nut, cap nut, domed cap nut, or dome nut ... barrel bolt, binding barrel, Chicago screw, post and screw or connector bolt ... 1 ⁄ 4: 1 ⁄ 4: 0 ...
All three patterns may also be combined with a slot for a flat-blade screwdriver. Usually they are provided with a 1/4 in (0.25 inches (6.4 mm)) flanged hex head. Non-standard metricized 5.5 millimetres (0.22 in) flanged hex heads can also be encountered. Also common are pan head screws - a low disk with a chamfered outer edge.
The Texas Instruments Hex-Bus interface (sometimes used unhyphenated as Hex Bus and with varying capitalization) was designed in 1982 and intended for commercial release in late 1983. It connects the console to peripherals via a high-speed serial link .
The male connector is hand-tightened (though versions with a hex nut are also available) and has an air gap between the center and outer conductors. The coupling has a 5 ⁄ 8-24 UNEF thread. Amphenol suggests tightening to a torque of 15 inch-pounds (1.7 N⋅m), [2] while Andrew Corporation suggest 20 inch-pounds (2.3 N⋅m) for their hex nut ...
Ads
related to: 1 4 to hex adapter connectorszoro.com has been visited by 1M+ users in the past month
Overall Customer Satisfaction 9.3 out of 10 - Bizrate.com
walmart.com has been visited by 1M+ users in the past month