enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Tolerance analysis - Wikipedia

    en.wikipedia.org/wiki/Tolerance_analysis

    Tolerance stackups or tolerance stacks are used to describe the problem-solving process in mechanical engineering of calculating the effects of the accumulated variation that is allowed by specified dimensions and tolerances. Typically these dimensions and tolerances are specified on an engineering drawing.

  3. Engineering tolerance - Wikipedia

    en.wikipedia.org/wiki/Engineering_tolerance

    For example, if a shaft with a nominal diameter of 10 mm is to have a sliding fit within a hole, the shaft might be specified with a tolerance range from 9.964 to 10 mm (i.e., a zero fundamental deviation, but a lower deviation of 0.036 mm) and the hole might be specified with a tolerance range from 10.04 mm to 10.076 mm (0.04 mm fundamental ...

  4. Geometric dimensioning and tolerancing - Wikipedia

    en.wikipedia.org/wiki/Geometric_dimensioning_and...

    Example of true position geometric control defined by basic dimensions and datum features. Geometric dimensioning and tolerancing (GD&T) is a system for defining and communicating engineering tolerances via a symbolic language on engineering drawings and computer-generated 3D models that describes a physical object's nominal geometry and the permissible variation thereof.

  5. Rotating unbalance - Wikipedia

    en.wikipedia.org/wiki/Rotating_unbalance

    A static balance (sometimes called a force balance [2] [3]) occurs when the inertial axis of a rotating mass is displaced from and parallel to the axis of rotation.Static unbalances can occur more frequently in disk-shaped rotors because the thin geometric profile of the disk allows for an uneven distribution of mass with an inertial axis that is nearly parallel to the axis of rotation.

  6. Allowance (engineering) - Wikipedia

    en.wikipedia.org/wiki/Allowance_(engineering)

    A tolerance is the expected limit of acceptable unintended deviation from a nominal or theoretical dimension. Therefore, a pair of tolerances, upper and lower, defines a range within which an actual dimension may fall while still being acceptable. In contrast, an allowance is a planned deviation from the nominal or theoretical dimension.

  7. Check weigher - Wikipedia

    en.wikipedia.org/wiki/Check_weigher

    There are several tolerance methods: . The traditional "minimum weight" system where weights below a specified weight are rejected. Normally the minimum weight is the weight that is printed on the pack or a weight level that exceeds that to allow for weight losses after production such as evaporation of commodities that have a moisture content.

  8. Accuracy and precision - Wikipedia

    en.wikipedia.org/wiki/Accuracy_and_precision

    In industrial instrumentation, accuracy is the measurement tolerance, or transmission of the instrument and defines the limits of the errors made when the instrument is used in normal operating conditions. [7] Ideally a measurement device is both accurate and precise, with measurements all close to and tightly clustered around the true value.

  9. IT Grade - Wikipedia

    en.wikipedia.org/wiki/IT_Grade

    An IT grade is an internationally accepted code system for tolerances on linear dimensions. Such code systems may be used to produce interchangeable parts. In engineering, the word tolerance refers to a range of allowable dimensions or values. Standard tolerance grades are a group of tolerances for linear sizes characterized by a common identifier.