Ad
related to: john deere code pcu 20 pin connector- Product Finder
Browse our products today!
Search by Part Number
- Order Free Samples
Request samples
Search by Part Number
- Product Finder
Search results
Results from the WOW.Com Content Network
Flat 5-pin connector (Towing vehicle side) This contact is not as common, but is compatible with the 4-pin connector in the way that a towing vehicle with this connector can be connected to a trailer with the 4-pin flat plug. The extra connection is often used to block the surge brakes when reversing with the trailer. #
The J1587 protocol uses different diagnostic connectors. Up to 1995, individual OEMs used their own connectors. From 1996 to 2001, the 6-pin Deutsch-connector was standard. Beginning in 2001, most OEMs converted to the 9-pin Deutsch. Some OEMs still use the 6-pin Deutsch. It has mostly been used for US made vehicles, and also by Volvo.
7-pin ISO 1724 trailer connector type 12N (Towing vehicle side). This connector uses a mix of pin and socket terminals. Physical design according to standard ISO 1724. [4] [8] The 7-pin connector uses all 7 pins on newer trailers according to the ISO standard. [9] [10] On older trailers there's sometimes a 5-wire setup using a 7-pin connector.
Connectors on this cable would be designated: 1A1W35P1; 1A1W35P2; ASME Y14.44-2008 continues the convention of Plug P and Jack J when assigning references for electrical connectors in assemblies where a J (or jack) is the more fixed and P (or plug) is the less fixed of a connector pair, without regard to the gender of the connector contacts.
Unlike the OBD-I connector, which was sometimes found under the bonnet of the vehicle, the OBD-II connector is required to be within 2 feet (0.61 m) of the steering wheel (unless an exemption is applied for by the manufacturer, in which case it is still somewhere within reach of the driver). SAE J1962 defines the pinout of the connector as:
Trailer connector according to NATO STANAG 4007. NATO uses a 12-pin connector [NATO 1] [NATO 2] according to STANAG 4007. [1] However, note that there are often deviations from the standard depending on which country it is applied, which means that the table below may not be accurate.
M12 A-coded 5-pin connector: For each connector size, the A-coding is the inspecific pinout variant and the only variant defined in varying numbers of pins. Ethernet cable with an M12 X-coded connector in one end and a modular connector in the other.
The connector has 20 or 24 pins. One of the pins belongs to the PS-ON wire (it is usually green). This connector is the largest of all the connectors. In older AT power supplies, this connector was split in two: P8 and P9. A power supply with a 24-pin connector can be used on a motherboard with a 20-pin connector.
Ad
related to: john deere code pcu 20 pin connector