Search results
Results from the WOW.Com Content Network
A variable in an experiment which is held constant in order to assess the relationship between multiple variables [a], is a control variable. [2] [3] A control variable is an element that is not changed throughout an experiment because its unchanging state allows better understanding of the relationship between the other variables being tested. [4]
The Hamiltonian of control theory describes not the dynamics of a system but conditions for extremizing some scalar function thereof (the Lagrangian) with respect to a control variable . As normally defined, it is a function of 4 variables
In optimal control theory, a control is a variable chosen by the controller or agent to manipulate state variables, similar to an actual control valve. Unlike the state variable, it does not have a predetermined equation of motion. [1] The goal of optimal control theory is to find some sequence of controls (within an admissible set) to achieve ...
An optimal control is a set of differential equations describing the paths of the control variables that minimize the cost function. The optimal control can be derived using Pontryagin's maximum principle (a necessary condition also known as Pontryagin's minimum principle or simply Pontryagin's principle), [8] or by solving the Hamilton ...
In open-loop control, the control action from the controller is independent of the "process output" (or "controlled process variable"). A good example of this is a central heating boiler controlled only by a timer, so that heat is applied for a constant time, regardless of the temperature of the building.
A scientific control is an experiment or observation designed to minimize the effects of variables other than the independent variable (i.e. confounding variables). [1] This increases the reliability of the results, often through a comparison between control measurements and the other measurements. Scientific controls are a part of the ...
In this case, the control variables may be wind speed, direction and precipitation. If the experiment were conducted when it was sunny with no wind, but the weather changed, one would want to postpone the completion of the experiment until the control variables (the wind and precipitation level) were the same as when the experiment began.
Departure of such a variable from its setpoint is one basis for error-controlled regulation using negative feedback for automatic control. [3] A setpoint can be any physical quantity or parameter that a control system seeks to regulate, such as temperature, pressure, flow rate, position, speed, or any other measurable attribute.